Adesso NuScan 2100 Series - Manual (Page 9)

Start of Configuration
DATA REDUNDANT CHECK
The option allows you to set
decoder data redundant
check.
Enable
Disable
INTER-MESSAGE DELAY
These series of scanners allow you to add a delay
between two consecutive messages. This delay will be
added before each data transmission.
None
100 msec
500 msec
1 Second
10
INTER-CHARACTER DELAY
This option governs delay time between consecutive
characters. Scanning the following labels can alter the
delay time.
None
10 msec
20 msec
50 msec
MESSAGE/BLOCK MODE SELECTION
This option allows you to treat scanned data as either an
independent message or a block message. In the
message mode, the data scanned will be transmitted
immediately. In block mode, the data scanned will be
appended to the message buffer if the scanner is
programmed in block mode. A block of message will
only be transmitted after a “Send” command is entered.
This mode is only available when the scanner is working
with code 39 labels. You are free to choose any
character as the “ Send” command.
Message
Block
End of Configuration
11