Adesso NuScan 2100 Series - Manual (Page 8)

GENERAL
CONFIGURATION
8
Start of Configuration
SCANNING MODE SELECTION (for laser scanner)
For series laser scanners, there are 3 scanning modes to suit
your application requirements.
Trigger Mode
Pulse Mode
The scanner becomes inactive
as soon as the data is
transmitted. It must be
triggered to become active
again.
The scanner will light up when
press the pulse mode trigger
switch once. And, the
scanner will turn off for next
pressing.
SCANNING MODE SELECTION (For CCD scanner)
The scanner becomes inactive as
soon as the data is transmitted. It
must be triggered to become
active again.
In auto scan mode, the scanner is
still active after the data is
transmitted, but the successive
transmission of the same bar code
is not allowed when the trigger
switch is pressed again.
This scanner will light up when
press the scanner trigger switch
once. And, the scanner will turn
off for next pressing.
This mode is similar to Auto scan
mode, but double reading for the
same barcode is prohibited if the
scanner switch is pressed.
Trigger mode
Auto scan mode
Alternate mode
Repeat mode
End of Configuration
9