Adesso NuScan 2100 Series - Manual (Page 3)

IMPORTANT NOTICE
This is a general guide for varies scanners, and
not all functions will perform in every scanners.
Other than specified in this guide, for any special
functions or specifications, please contact your
dealer for details.
Every effort is made to ensure the accuracy of our
product information; however, we accept no
responsibility for errors or omissions including, but
not limited to, the implied warranties of
merchantability and fitness for a particular purpose.
We shall not be liable for errors contained herein
or for incidental consequential damages in
connection with the furnishing, performance, or
use of this material.
Specification or version may be subject to change
without notice. The actual specification and version
are based on the product delivered.
TABLE OF CONTENTS
Introduction............................................................1
Default Parameters................................................2
Program Procedure ...............................................5
System Setting ......................................................6
General Configuration
Scanning Mode Selection ......................................9
Inter- Message Delay...........................................10
Inter- Character Delay .........................................11
Message/ Block Mode Selection..........................11
Beeper Tone Selection.........................................12
Interface Configuration
RS-232C Serial Communication Parameters Setting
Handshaking
Protocol .................................15
ACK/ NAK Response Time Setting .............16
Baud Rate ...................................................16
Data Bit .......................................................17
Stop Bit........................................................17
Parity Setting...............................................17
Message Terminator....................................18
Keyboard Emulation Parameters Setting.............19
Keyboard
Type Selection ............................19
Language Selection ....................................21
Message Terminator....................................22
Function Key Emulation ..............................23
Capital Lock Setting ....................................23
Wand Emulation Parameters Setting ...................24
Emulation Data Output Selection ................25
Wand Emulation Narrow/Wide Ratio ...........25
Cursor Pad Work at Numlock ......................25
USB Interface Parameters Setting.......................26
Keyboard Type ............................................26
Message
Terminator....................................26
The Symbologies
Reading Code Selection ......................................28
Code 39 Parameters Setting ...............................30
Interleaved 2 Of 5 Parameters Setting.................31
i