AOC A17UX231 User Manual

Page 4

16. This product may contain lead or mercury. Disposal of these materials may be

regulated due to environmental considerations. For disposal or recycling

information, please contact your local authorities or the Electronic Industries

Alliance: www.eiae.org

17. Damage Requiring Service – The appliance should be serviced by qualified

service personnel when:

A. The power supply cord or the plug has been damaged; or

B. Objects have fallen, or liquid has been spilled into the appliance; or

C. The appliance has been exposed to rain; or

D. The appliance does not appear to operate normally or exhibits a marked

change in performance; or

E. The appliance has been dropped, or the enclosure damaged.

18. Tilt/Stability – All televisions must comply with recommended international

global safety standards for tilt and stability properties of its cabinets design.



Do not compromise these design standards by applying excessive pull

force to the front, or top, of the cabinet, which could ultimately overturn

the product.



Also, do not endanger yourself, or children, by placing electronic

equipment/toys on the top of the cabinet. Such items could

unsuspectingly fall from the top of the set and cause product damage

and/or personal injury.

19. Wall or Ceiling Mounting – The appliance should be mounted to a wall or

ceiling only as recommended by the manufacturer.

20. Power Lines – An outdoor antenna should be located away from power lines.
21. Outdoor Antenna Grounding – If an outside antenna is connected to the

receiver, be sure the antenna system is grounded so as to provide some

protection against voltage surges and built up static charges.

Section 810 of the National Electric Cord, ANSI/NFPA No. 70-1984, provides

information with respect to proper grounding of the mats and supporting

structure grounding of the lead-in wire to an antenna-discharge unit, size of

grounding connectors, location of antenna-discharge unit, connection to

grounding electrodes and requirements for the grounding electrode. See Figure

below.