Panasonic DMWFL500E - Manual (Page 21)

21
VQT0Z62
Push the [MODE] button, and select the flash
mode. (P20)
1 Turn the [GN/ISO] dial to set the
ISO sensitivity.
2 Push the [ZOOM] button to set
the zoom value to the focal
length of the lens.
3 Turn the [F] dial and set it to the
aperture of the lens.
≥ If the combination of the ISO sensitivity
and aperture are outside the usable
range, a warning is given in the form of
the flashing ISO sensitivity and aperture
displays. In a case like this, change the
ISO sensitivity and aperture.
4 Push the shutter button all the
way down, and take the photo.
5 Check that the [AUTO CHECK]
lamp is flashing.
≥ If the [AUTO CHECK] lamp continues to
flash for about 5 seconds, it means that
the unit has fired successfully.
[AUTO]
GN/ISO
ZOOM
F
AUTO
CHECK
VQT0Z62.book 21 ページ ２００６年６月２２日 木曜日 午前１１時４６分