Panasonic DMWFL500E - Manual (Page 15)

15
VQT0Z62
Push the [MODE] button, and select the flash
mode. (P13)
≥ The flash working range is shown on the
display panel in line with the settings of the
digital camera.
A: Flash working range
≥ If the settings on the digital camera (ISO
sensitivity and aperture) are outside the
combinations of the ISO sensitivity and
aperture which can be adjusted, the flash
working range is not displayed and the
user is warned by the flashing of [ISO]
and [F] on the display. In a case like this,
change the digital camera settings.
1 Check that the distance to the
subject is within the flash
working range.
≥ If the subject is outside the range, adjust
the aperture of the lens or change the
distance to the subject.
≥ The flash working range changes
depending on the type and settings (ISO
sensitivity, aperture and focal length) of
the digital camera used.
2 Push the shutter button all the
way down, and take the picture.
3 Check that the [AUTO CHECK]
lamp is flashing.
≥ If the [AUTO CHECK] lamp continues to
flash for about 5 seconds, it means that
the unit has fired successfully.
∫
Combinations of the ISO sensitivity and
aperture which can be adjusted in the
[AUTO] mode
[AUTO]
A
ISO
sensitivity
Aperture
3200 F8 to F32
1600 F5.6 to F32
800 F4 to F32
400 F2.8 to F32
200 F2 to F32
100 F1.4 to F22
50 F1.4 to F16
25 F1.4 to F11
AUTO
CHECK
VQT0Z62.book 15 ページ ２００６年６月２２日 木曜日 午前１１時４６分