Panasonic TYTP42P8S - Manual (Page 13)

13
Installation of the USB Driver
Setup is completed when all the files of the driver are copied.
7 Click to close this wizard.
8 The new hardware window is displayed again, and the
driver for the assumed COM port is installed.
1 Click on [Start] [Settings] [Control Panel]
Double-click on “the system” icon of the control panel,
and open the properties of the system.
The properties of the system are opened.
2 Then click on the “Device Manager” tab.
3 Double-click “Ports [COM&LPT]”. Confirm that “USB-
Serial for Touch Panel V2 (COMx)” is found in “Ports
[COM&LPT]”.
(COMx) is the COM port number for using a touch panel.
As for the COM port number, the setup number varies in
the use environment of the PC.
4 Next, double-click “Universal Serial Bus controllers”.
5 Confirm that “MATSUSHITA USB-Serial Bridge for Touch
Panel V2” is found in “Universal Serial Bus controllers”.
6 Click on this button.
The setup of the USB driver is finished.
COM port number is confirmed with “Device Manager”