Panasonic EYFLA6PR - Manual (Page 9)

- 9 -
Forward Rotation Switch
Operation
1. Push the lever for forward rotation.
. Depress the trigger switch slightly to start
the tool slowly.
3. The speed increases with the amount of
depression of the trigger for efficient tight-
ening of screws. The brake operates and
the bit stops immediately when the trigger
is released.
4. After use, set the lever to its center posi-
tion (switch lock).
Reverse Rotation Switch
Operation
1. Push the lever for reverse rotation. Check the
direction of rotation before use.
. Depress the trigger switch slightly to start the
tool slowly.
3. After use, set the lever to its center posi-
tion (switch lock).
CAUTION:
• To eliminate excessive temperature
increase of the tool surface, do not
operate the tool continuously using two
or more battery packs. Tool needs cool
off time before switching to another
pack.
Tightening confirmation lamp
• The tightening confirmation lamp can be
used to check whether the torque control
function was activated.
Tool status Lamp display
Tightening complete
(with torque control
function operation)
Green
(For approx.
seconds)
• Tightening not complete
• Tightening complete
with retightening within 1
second
Red
(For approx.
seconds)
The automatic stop
function has been
activated.
Red
(For approx. 5
minutes)
CAUTION:
• When the tool stops automatically after
the switch is released during impact-
mode tightening and then re-engaged
within 1 second, the red lamp will light up
to indicate the risk of excessive torque
application as a result of re-tightening.
NOTE
• The tightening confirmation lamp will
not turn on under the following condi-
tions:
• When the torque clutch is set to “F”
• During reverse rotation operation
• The lamp turns off when the tool is in
operation.
Control Panel
(1) () (3)
(1) LED light
Pressing the button toggles the LED light on
and off.
The light illuminates with very low current, and
it does not adversely affect the performance of
the tool during use or its battery capacity.
CAUTION:
• The built-in LED light is designed to illu-
minate the small work area temporarily.
• Do not use it as a substitute for a regu-
lar flashlight, since it does not have
enough brightness.
This tool has the built-in LED light.
Caution: DO NOT STARE INTO BEAM.
Use of controls or adjustments or performance
of procedures other than those specified herein
may result in hazardous radiation exposure.