Assembly, Attaching or removing bit, Attaching socket (pin type) – Panasonic EYFLA6PR User Manual

Page 6: Removing socket (pin type)

- 6 -

7) Do not strain the tool by holding the speed

control trigger halfway (speed control

mode) so that the motor stops.

Symbol

Meaning

Volts

Direct current

No load speed

… min

-1

Revolutions or reciprocations

per minutes

Electrical capacity of battery

pack

ASSEMBLY

Attaching or Removing Bit

NOTE:

• When attaching or removing a bit, discon-

nect battery pack from tool or place the

switch in the center position (switch lock).

1. Hold the collar of quick connect chuck and

pull it out from the tool.

. Insert the bit into the chuck. Release the

collar.

3. The collar will return to its original position

when it is released.

4. Pull the bit to make sure it does not come out.
5. To remove the bit, pull out the collar in the

same way.
CAUTION:

• If the collar does not return to its origi-

nal position or the bit comes out when

pulled on, the bit has not been properly

attached. Make sure the bit is properly

attached before use.

EYFLA4A/EYFLA4AR/EYFLA5A/EYFLA5AR

1 mm

(15/3")

9 mm – 9.5 mm

(3/64" – 3/8")

6.35 mm

(1/4")

Attaching Socket (Pin type)

• Remove the socket’s rubber ring and pin.

rubber ring

groove

Attach the socket to the tool.

Insert the pin. (Taking care to align the pin

holes on the socket and tool.)

Attach the rubber ring by sliding it into place

over the groove.

NOTE:

Be sure to attach the rubber ring to prevent

the pin from falling out.

Removing Socket (Pin type)

Remove the rubber ring.

Remove the pin.

Remove the socket from the tool.

NOTE:

Keep the temperature of the tool above

the freezing point (0°C/3°F) when attach-

ing sockets to or detaching them from

the square drive on the tool. Do not use

excessive force when attaching or detach-

ing sockets.