Antec SOLO II - Manual (Page 24)

24
4.1 I NCLUDED 120 MM T RUE Q UIET ™ REAR FAN
The SOLO II comes with a 120 mm TrueQuiet™ rear fan. This fan has a two-speed switch that lets you choose
the speed best suited to your need. The switch is located at the rear of the case. The default fan speed setting
is Low.
120 mm Fan Specifications:
Size: 120 x 25mm two-speed fan
Rated Voltage: 12V DC
Operating Voltage: 10.8V ~ 13.2 V
Speed Input Current Air Flow Static Pressure Noise Input Power
High
1000RPM 0.12A 1.0m³ / min
(35.8 CFM) 0.29 mm-H
2
O
(0.7inch-H
2
O)
19.9 dBA 1.44W
Low
600RPM 0.06A 0.6m³ / min
(21.5 CFM) 0.27 mm-H
2
O
(0.1inch-H
2
O)
8.9 dBA 0.72W
4.2
W ASHABLE A IR F ILTERS
There are two filters located behind the SOLO II’s front bezel.
To clean the filter: Open the front bezel and locate the filter tabs. Push down on the tab and pull the
filter away from the case to completely remove it.
Note: The minimum voltage to start a typical TrueQuiet™ fan is 7V. We recommend that you set the fan speed
to High if you choose to connect the fan(s) to a fan control device or to the Fan-Only connector found on
some Antec power supplies. A fan control device regulates the fan speed by varying the voltage, which
may start as low as 4.5V to 5V. Connecting a TrueQuiet ™ fan set on Low to a fan-control device may
result in the fan not being able to start because the already lowered voltage from the fan control device
will be further reduced by the TrueQuiet ™ circuitry below 5V.