Panasonic KXTGA806FX - Manual (Page 6)

6
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {ic} for
few seconds to turn the handset on.
1 Handset:
Lift the handset and press {ic}.
2 Base unit:
Proceed with the operation for your model.
N
KX-TG6611/KX-TG8051/KX-TG8611
Press and hold {x} for about 5 seconds. (No registration tone)
N
KX-TG6621/KX-TG8061
Press and hold {x} for about 5 seconds, until the registration tone sounds.
• If all registered handsets start ringing, press {x} again to stop, then repeat
this step.
3 Handset:
Place the handset on the base unit or charger.
• Continue the operation even when the handset display shows
“Please wait for 1 minute.”.
4 With the handset still on the base unit or charger, wait until a confirmation tone
sounds and w is displayed.
Note:
• If an error tone sounds, or if _ is displayed, register the handset according to
the base unit’s operating instructions.
• The KX-TG6611/KX-TG8051/KX-TG8611 does not feature an answering
system.
• Answering system features are available only when this handset is registered
to the KX-TG6621/KX-TG8061.
For your safety
To prevent severe injury and loss of life/property, read this section carefully before using the
product to ensure proper and safe operation of your product.
WARNING
Power connection
• Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may
cause electric shock and/or excessive heat resulting in a fire.
• Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the
power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation
defect from moisture, etc. resulting in a fire.
TGA661FX(fx).book Page 6 Thursday, February 24, 2011 9:03 AM