Panasonic KXTGA681FX User Manual
Page 5

5
Place the handset on the charger for about 7 hours before initial use.
Note:
• The handset display may show “Please wait for 1 minute.” when the handset is
placed on the charger if it is not registered to the base unit.
• If the batteries are fully charged, but the operating time seems to be shorter, clean the
battery ends (S, T) and the charge contacts with a dry cloth and charge again.
Display language
16 display languages are available.
1
{
B} (right soft key) (11)
2
{
r}
: Select your desired language. s {OK} s {ic}
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold {ic} for few seconds
to turn the handset on.
1
Handset:
Lift the handset and press {ic}.
2
Base unit:
Press and hold {x} for about 5 seconds.
• Depending on the base unit, a registration tone sounds.
• If all registered handsets start ringing, press {x} again to stop, then repeat this step.
3
Handset:
Place the handset on the base unit or charger.
• Continue the operation even when the handset display shows “Please wait for 1
minute.”.
4
With the handset still on the base unit or charger, wait until a confirmation tone sounds
and w is displayed.
Note:
• If an error tone sounds, or if _ is displayed, register the handset according to the base
unit’s operating instructions.
You can select “ ”, “ ”, “ ”, “ ”, “ ”,
“ ”, “ ”, “ ”, “ ”, “ ”,
“ ”, “ ”, “ ”, “ ”, “ ”, or “ ”.
TGA681_786FX(fx).book Page 5 Tuesday, February 19, 2013 5:21 PM