Albatron Technology KI51PV-754 - Manual (Page 15)

Mainboard KI51PV-754
11
Audio Ports: Sound
This mainboard provides three audio ports, the Mic-in, Line-in
and Line-out. These are the standard audio ports that provide
basic audio function.
Line-In ( Blue )
This port is for audio input and connects to external audio
devices such as CD player, tape player, etc. When the Super 5.1
Channel Audio Effect is enabled, this port will output audio for the
rear speakers.
Line-Out ( Green )
This port is an output audio port used for connecting to speakers or a headset. When the Super
5.1 Channel Audio Effect is enabled, this port will output audio for the front speakers.
Mic-In (Pink)
This port is for connecting to a microphone. When the Super 5.1 Channel Audio Effect is
enabled, this port will output audio for your subwoofer/center speakers.
Connectors
Floppy Disk Drive Connector: FDC
The mainboard provides a standard floppy disk drive connector (FDC) that supports 360KB/
720KB/1.2MB/1.44MB/2.88MB floppy disk drives using a FDD ribbon cable.
Hard disk drive Connectors: IDE1/IDE2
The mainboard provides two IDE connectors that support Ultra ATA 66/100/133 IDE devices.
You can attach a maximum of four IDE devices, such as hard disk drive (HDD), CD-ROM,
DVD-ROM, etc. using IDE ribbon cables.
Primary IDE Connector: IDE1
In general, two IDE devices can be attached onto one IDE connector. If you attach two IDE
HDDs, you must configure one drive as the master and the other one as the slave.
Secondary IDE Connector: IDE2
The IDE2 connector can also be attached with two IDE HDDs, and remember to configure one
drive as the Master and the other one as the Slave as well. In addition, it is recommended that
attach the optical devices such as CD-ROM, DVD-ROM, etc. onto this IDE2 connector.
This mainboard supports Super 5.1 Channel Audio Effect, and you can
transfer 2-channel to 6-channel audio by using a SPDIF Card (Optional) to
enable 6 speaker audio. See Appendix I for more information.