Ariston AW122 - Manual (Page 18)

18
Installation Instructions
ELECTRICAL SHOCK HAZARD
Plug washer-dryer into a
grounded 3 prong outlet.
Do not remove ground prong.
Do not use adapter.
Do not use an extension cord.
Failure to follow these
instructions can result in death,
fire, or electrical shock.
WARNING
!
Complete the Installation
• Check to be sure all parts are now installed. If
there’s an extra part, go back through the steps to
see which step was skipped.
• Check to be sure you have all your tools.
• Dispose/recycle all packaging materials.
• Read this manual.
Final Installation Checklist
Instructions and Installation Kit have been re-
moved from the tub.
Transit bolts/spacers have been removed.
Washer is plugged into electrical outlet and is
properly grounded.
Water hoses are connected to the faucets with
inlet screens and washers.
Water is turned on and checked for leaks at
faucet and water valve connections.
Drain hose is properly located into drain facility
and is not collapsed or damaged.
Washer has been leveled.
Test for proper operation (see below)
To test and clean the washer
Measure 1 to 2 tbsp. of powdered High Efficiency (HE)
detergent.
• Pour the detergent into
compartment 2 in the
dispenser drawer (see
Dispenser Drawer).
• Select program “4” on the
PROGRAMS dial.
• Select HOT on the TEM-
PERATURE knob
• Press the ON-OFF button
(in). Allow the washer to
complete the full cycle. (It
will take approx. 40 min.)








IMPORTANT!
Should you move residence in the future,
the Transit Screws/Spacers should be
reinstalled to support the inside of the
washer and prevent damage WHEN
TRANSPORTING.