Nilfisk-ALTO 580 P User Manual

Page 12

ENGLISH

USER MANUAL

FLOORTEC R 580 P

146 2603 000(1)2005-03 A

AFTER USING THE MACHINE

After working, before leaving the machine:

–

Close the suction by means of the related lever
(13, Fig. B), then press the filter-shaker switch
(10, Fig. B) for a short interval; open the suction
again.

–

Empty the hopper (4, Fig. C) (see previous
paragraph);

–

Lift the main broom with the lever (20, Fig. B).

–

Lift the side brooms with the levers (17 and 18,
Fig. B).

–

Run the engine at idle by setting the engine
throttle lever (24, Fig. B) to MIN (idle speed);

–

Stop the engine by turning the ignition key (14,
Fig. B) to “0” position;

–

Remove the ignition key from the switch (14,
Fig. B);

–

Engage the parking brake by pressing the brake
pedal (22, Fig. B), then activate the brake lock
control lever (15).

PUSHING/TOWING THE MACHINE

To push the machine, proceed as follows:
– Stop the engine by turning the ignition key (14, Fig. B)

to “0” position;

– Raise the hood (13, Fig. C).
– Remove the screw (15, Fig. V).
– Close the hood (13, Fig. C);
– Push the machine.
– After pushing the machine, install the screw (15, Fig. V).

WORKING LIGHT ADJUSTMENT

If it is necessary to adjust the working light beam aiming
(9, Fig. C), operate on the screws (23).

MACHINE LONG INACTIVITY

If you foresee that the machine will not be used for more
than 30 days, proceed as follows:
1.

Check that the area where the machine is going to be
kept is dry and clean;

Disconnect the battery (2, Fig. V) negative terminal (–
);

Treat the petrol engine (7, Fig. V) according to the
indications in the related User Manual.

FIRST PERIOD OF USE

After the first period of use (first 5 hours) it is necessary to
carry out the following operations:
1.

Check that the machine fastening and connecting
elements are correctly tightened; check that the
visible parts are whole and that there are no leaks;

Replace the petrol engine oil (see “Maintenance”
chapter).