Panasonic TYWK4P1RW - Manual (Page 3)

3
English
3
TY-WK4P1RW
Wall-hanging bracket (Adjustable angle type)
Parts used to assemble the wall-hanging bracket
ヂ Base upper and lower
fittings (2)
ッ Bracket base left fitting
(1)
ツ Bracket base right fitting
(1)
ヅ M5x8 screws for
assembling the
fixture (4)
Parts used for installation
View of fully assembled fixtur ㇙ M8×32 Allen head
countersunk screws (4)
㇜ Spacers (4)
㇚ Dished toothed washers (4) ㇝ M5x50 Unit fastening screws (2)
㇛ Insulation spacers (4) ㇞ Allen wrench (included tool) (1)
Precautions for wall-hanging bracket fitting
♦ Installation and removal work must be carried out only by a qualified technician.
If the unit is installed or removed improperly, the display may fall down and personal injury may result.
♦ The wall-hanging bracket is for use in attaching a plasma TV unit to a vertical wall for viewing. Do not fit to
any surface other than a vertical wall.
♦ To ensure correct plasma TV performance and prevent trouble, do not fit at any of the following locations.
• Near sprinklers or fire/smoke detectors
• Where there is a risk of exposure to vibration or impact
• Near high-voltage wires or dynamic power supplies
• Near sources of magnetism, heat, water vapor or soot
• Locations exposed to air blown from heating equipment
• Where droplets of condensation from an air conditioner or other unit may form.
♦ Fit using techniques suited to the structure and materials of the fitting location.
♦ Use commercially available screws with a nominal diameter of 6 mm (0.2 inches) that are suited to the wall
material (wood, steel frame, concrete etc.) you are fitting the bracket to.
♦ For the TV power supply plug, use a power supply outlet that can be reached easily.
♦ Ensure good air flow so that the equipment ambient temperature does not exceed 40 °C (104 °F). Failure to
do this may cause heat to build up inside the plasma TV, resulting in malfunction.
♦ Spread a soft blanket or cloth over the floor so that the plasma TV and floor will not be marked or scratched
during the assembly and installation work.
♦ When screwing down the parts, ensure that the screws are neither insufficiently tightened nor over tightened.
♦ Take sufficient care to ensure safety around you when performing the assembly and installation work or while
moving about during the course of the work.
♦ Do not install the Plasma TV underneath ceiling lamps (spotlights, halogen lamps, etc.). Otherwise, the
cabinet may be bent or damaged by high heat.
Components [ The images shown in this manual are for illustrative
purpose only.]
English