Alto-Shaam COOKING & HOLDING OVEN AS-250 - Manual (Page 13)

AS-250
inStAllAtion
/
operAtion
/
Service mAnuAl pg
. 11
O P E R A T I N G I N S T R U C T I O N S
Programming a Preset
Select the product to be programmed and begin programming with the oven control power O
ff
.
Press and release control O
n
/O
ff
key. The oven will beep for one second and power to the unit
will be indicated by an illuminated green indicator light located in the upper left corner of the
O
N
/O
ff
key. The oven will begin operating in the hold mode. The amber H
old
indicator will be
illuminated and the last set hold temperature will be displayed.
To set Cook temperature — Press c
ook
Key. Oven preheat indicator will illuminate and the last
set cooking temperature is displayed. To change the cook temperature, press the u
p
or d
own
a
rrow
Keys.
If cooking by time — press the t
ime
Key. The green t
ime
indicator will illuminate and the last set
cooking time will be displayed. To change the set time, press the u
p
or d
own
a
rrow
Key. The
display will alternate between the set temperature and the elapsed time.
If cooking by probe — press the p
robe
Key. The green p
robe
indicator will illuminate and the last
set internal product temperature will be displayed. To change the set temperature, press the u
p
or d
own
a
rrow
Key. The display will alternate between the set temperature, the elapsed time,
and the probe temperature.
To set Hold temperature — Press the h
old
Key. The green cook indicator light will remain
illuminated. To change the hold temperature, press the u
p
or d
own
a
rrow
Key. The display will
alternate between the set hold temperature and the amount of time the product has been in the
hold mode. Oven will remain in the h
old
mode until the o
N
/o
ff
key is pressed.
Select a letter code for the product programmed by the previous steps. Press and hold the selected
p
reset
key for two seconds. When the preset has been saved, you will hear a one second beep and the
preset light will illuminate.
Note: Only one preset can be programmed at a time. If programming an additional preset is
desired, the unit must be started and stopped either by cycling the power to the cavity or by
pressing the S
tart
/S
top
key. The last p
reset
Key used will be the oven cooking run sequence
for the next product to be programmed. Settings can be manually changed for the next
product and an alternate pre-programmed letter key selected.
Erasing a Preset
To erase a program, the oven must be in either the power-up hold mode or in the preheat mode. The oven
cannot be running a p
reset
Menu program.
When the oven is in the power-up hold mode or in the preheat mode, press and hold the c
aNcel
Key and
then the appropriate letter p
reset
Key to be erased for two seconds. When the preset has been erased the
oven will beep for one second.
IMPORTANT -
After programming a specific product into memory in a programmable
preset key, it is very important to make a written permanent record of the product and the
program letter assigned. Menu card (PE-23384) is provided for this purpose.
I
o
I
o
I
o
I
o
I
o
I
o
I
o
I
o
I
o
I
o