Panasonic RRXS450E - Manual (Page 28)

VQT4J81
28
28
Level meter
OVER indication
Recording level
* If the level meter swings and “ ” is displayed, this
means the recording level is too high. Adjust the level
within the “ ” range even if the recording sound
reaches the highest level.
* The input level (volume input to this unit) for recording
is combination of the recording level and microphone
sensitivity.
The input level image is as below.
1 30 1 30
Recording
level
MIC SENS.
LOW HIGH
* No sound is recorded at the recording level 0, and
“ MUTE ” is displayed.
* The recording level can also be adjusted during
recording or while recording is paused.
* When [MENU] is pressed during recording standby,
the microphone sensitivity ( ➜ page 26), “LOW CUT
FILTER” ( ➜ page 26) and recording EQ (➜ page 29)
can be set.
Setting the recording level manually
Setting the recording peak limiter to ON
Even if the recording level adjustment is
MANUAL, when the excessive volume is input,
the recording level is automatically adjusted and
the sound distortion is reduced.
• Press [STOP g/RETURN] to stop the unit.
1 Press [MENU].
2 Press +, – to select “MIC REC MENU”
and press [q OK] to enter.
3 Press +, – to select “PEAK LIMITER”
and press [q OK] to enter.
4 Press +, – to select “ON”
and press [q OK] to enter.
(The factory setting is “OFF”.)
To exit the setting screen, press [F2 (CLOSE)].
* When the recording level adjustment is AUTO, the
recording peak limiter function will be activated
regardless of the above setting.
* If the level meter swings, “ ” is displayed regardless
of the recording peak limiter setting.
VQT4J81_RR-XS450_420-E_En.indd 28 VQT4J81_RR-XS450_420-E_En.indd 28 2012/05/29 9:35:44 2012/05/29 9:35:44