Altinex Computer/Component Video+ Audio Dual Twisted Pair Transmitter MT115-110 - Manual (Page 11)

MULTITASKER
400-0433-003 10
3. [CnS]
This command saves the card settings and
displays the status. After the system is reset or
powered off and on, the settings are restored.
Cn = card number
S = save configuration
Example:
Save the status by sending [C4S]. The
feedback returned will be similar to the following:
INPUT#1 VIDEO GAIN 4
EQUALIZATION 32
INPUT#2 VIDEO GAIN 4
EQUALIZATION 32
SAVED
FEEDBACK COMMANDS
The next four commands are a function of both
the card and the front panel and are only
available with MultiTasker Front Panel systems
that have the following firmware:
690-0122-015 = Version 015 or later.
690-0123-004 = Version 004 or later.
690-0124-018 = Version 018 or later.
Send the command [VER], and the system will
respond with feedback that includes the
following:
690-0122-015 690-0123-004 690-0124-018
Check the last three digits against the numbers
above to determine if the option is available.
4. [?]
This command will return general information
about the MultiTasker and cards installed in the
unit.
Command Format: [?Ui]
Ui = Unit ID (i = from 0 to 9)
Example:
A MultiTasker with unit ID 1 has a front panel
with part number MT101-101 and contains an
MT103-122, MT103-123, and MT115-110. Send
the command [?U1] and receive the following
feedback:
[(MT101-101U1)(MT103-122C01)
(MT103-123C02)(MT115-110C03)]
MT101-101U1 = Panel Number and Unit ID
MT103-122C01 = An MT103-122 is in slot 1
MT103-123C02 = An MT103-123 is in slot 2
MT115-110C03 = An MT115-110 is in slot 3
5. [?C]
This command will return general information
about the card and its status.
Command Format: [?Cn]
Cn = Card ID (n = # from 1 to max slots)
Example:
The MT115-110 in slot 3 has Input 1 connected
to all outputs. Each input is set to a gain level of
4 and an equalization value of 32. Send the
command [?C3] and receive feedback similar to
the following.
[(MT115-110C03)(VR690-0231-001C03)
(GN0404C03)(EQ3232C03)]
All status feedback is enclosed in brackets, “[ ]“.
Each data field within the status is enclosed in
parentheses. The first two characters identify
the status type. The last three characters are the
card’s ID.
MT115-110 = Card model number
VR690-0231-001 = Firmware version
GN0404 = Gain levels
EQ3232 = Equalization values
The gain and equalization settings are read from
left to right. The first 2 digits are for Input 1 and
the last 2 digits are for Input 2.
In this case, both gains are set to 4 and both
equalization levels are set to 32.