Altinex Computer/Component Video+ Audio Dual Twisted Pair Transmitter MT115-110 - Manual (Page 10)

MULTITASKER
400-0433-003 9
7.2 DESCRIPTION OF COMMANDS
Each command consists of three parts:
Function, Card ID, and Unit ID.
[ Function , Card ID , Unit ID ]
Example: [VERC3U2]
VER= Function
C3 = Card ID or Group ID
U2 = Unit ID (optional for Unit ID 0)
For Function, see a detailed explanation under
each command description.
The card ID is a unique identifier. It is equal to
the enclosure slot number, or it may be an
assigned value. As the slot number, the value
can range from 1-4 up to 1-to-20 depending on
the enclosure. If the value is assigned, the ID
may be a maximum of 99. Card ID 0 (C0) is
used for the controller and cannot be
reassigned.
The group ID is a number representing a group
of cards defined with the [WR] command. When
using the group ID, all cards in the group will
perform the given instruction.
NOTE: In this manual, cards will be referenced
by their ID (C1, C2...C99). Typically, the ID
number will be equivalent to the slot number.
Groups will be referenced by their ID (G1-G8).
Changing the position of a card will significantly
affect the commands recorded on software
definitions or third-party control systems.
The unit ID has a value from 0 to 9. Unit ID 0
should be used for single unit operation. If the
unit ID is set to zero, each command may be
used without Ui. Use the command [SETU0], as
explained in the MT100-100 User’s Guide.
Example:
[VERC3]: For Unit ID Zero
[VERC3Ui]: For Unit ID other than Zero
[VERC3]: Equivalent to [VERC3U0]
COMMANDS
1. [VER]
This command displays the software version
and card type for the MT115-110 card.
Command Format: [VERCn]
Cn = Card ID (n = slot # from 1 to max slots)
Example:
An MT115-110 card is in slot 3. Send the
command [VERC3], and the system will return
feedback similar to the following:
[MT115-110 690-0231-001 C03]
MT115-110 = Model number
690-0231-001 = Firmware version
C03 = Card ID
2. [C]
This command displays the status of the card.
Command Format: [Cn]
Cn = Card ID (n = # from 1 to max slots)
Example:
There is an MT115-110 card in slot 3. Sending
the command [C3] will yield feedback similar to
the following:
INPUT#1 VIDEO GAIN 4
EQUALIZATION 32
INPUT#2 VIDEO GAIN 4
EQUALIZATION 32
In this case, both card inputs are set for a video
gain of 4 and an equalization of 32.
If there is no card in slot 4, sending the [C4]
command will not return any feedback.