Ariens Sno-Thro 932105 - 8526 - Manual (Page 12)

GB - 12
Run-in Attachment Belt
1. Start unit in a well-ventilated area
according to Starting and Shut-Off in
Operation.
2. Engage attachment clutch lever and run
attachment for about 15 minutes.
3. Stop unit, wait for all moving parts to stop,
and remove spark plug wire.
4. Adjust belt finger, if necessasry. See
Attachment Drive Belt Replacement on
page 22.
5. Adjust clutch according to Attachment
Clutch/Brake Adjustment in Service and
Adjustments.
z 1. Headlight
2. Electric Starter (932105)
3. Oil Fill and Dipstick
4. Discharge Chute Deflector
5. Discharge Chute
6. Impeller
7. Auger
8. Scraper Blade
9. Recoil Starter Handle
10. Primer Bulb
11. Oil Drain Plug
12. Attachment Clutch Lever
13. Deflector Remote Control
14. Speed Selector
15. Chute Crank
16. Traction Drive Clutch Lever
17. Ignition Switch, push-pull
18. Choke
19. Throttle (Engine Stop)
20. Runner(s)
21. Axle Lock Pin
22. Belt Cover
23. Fuel Shut-off Valve
24. Spark Plug and Wire
25. Gas Tank and Cap
CONTROLS AND FEATURES
Figure 8
OS6785
OS6740
16
17
18
19
15
2
14 12
9
25
3
10
24
20
22
4
5
6
7
8
1
21
23
13
11
OS6820