Specifications, Main unit – Sony LBT-LCD7Di User Manual
Page 126

MHC-GZR33Di/LBT-LCD7Di.GB.4-143-233-12(1)
1
GB
On heat buildup
Heat buildup on the unit during operation is
normal and is not cause for alarm.
Do not touch the cabinet if it has been used
continuously at a high volume because the
cabinet may have become hot.
Do not obstruct the ventilation holes.
In case color irregularity is observed
on a nearby TV screen
With the magnetically shielded type of
speakers, the speakers can be installed near a
TV set. However, color irregularity may still
be observed on the TV screen depending on
the type of your TV set. In this situation, turn
off the TV, wait 15 to 30 minutes, and turn it
back on. If there is no improvement, move the
speakers far away from the TV.
IMPORTANT NOTICE
Caution: If you leave a still video image
or on-screen display image displayed on
your TV for an extended period of time via
this system, you risk permanent damage
to your TV screen. Projection TVs are
especially susceptible to this.
Cleaning the cabinet
Clean this system with a soft cloth slightly
moistened with a mild detergent solution.
Do not use any type of abrasive pad, scouring
powder, or solvent, such as thinner, benzine,
or alcohol.
Specifications
Main unit
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
(LBT-LCD7Di The United States model
only)
With 6 ohm loads, both channels driven,
from 120 10,000 Hz; rated 85 watts per
channel minimum RMS power, with no
more than 1% total harmonic distortion
from 800 milliwatts to rated output.
Amplifier section
The following measured at AC 120 V, 60 Hz
(North American model)
The following measured at AC 230 V,
50/60 Hz (European model)
The following measured at AC 240 V,
50/60 Hz (Australian model)
MHC-GZRDi
Power output (rated):
105 W + 105 W (at 6 Ω, 1 kHz, 1%
THD)
RMS output power (reference):
180 W + 180 W (per channel at 6 Ω,
1 kHz, 10% THD)
LBT-LCD7Di
Power output (rated):
105 W + 105 W (at 6 Ω, 1 kHz, 1%
THD)
RMS output power (reference):
180 W + 180 W (per channel at 6 Ω,
1 kHz, 10% THD)