beautypg.com

Step3: basic hookups, Selecting the best hookup option, Step 3 : basic hookups – Sony SLV-D100 User Manual

Page 14

background image

14

Basic hookups

Step 3 : Basic hookups

Selecting the best hookup option

There are many ways in which your DVD-VCR can be hooked up. To hook up your
DVD-VCR so that it works best for you, first scan through the table below. Then use
the accompanying diagrams and procedures on the following pages to set up your
DVD-VCR.

If your TV has audio/video inputs, refer to page 15 for audio/video (A/V) hookup.
Then follow one of the hookups below. If your TV does not have A/V inputs, go
directly to one of the hookups below.

After you have completed the connections, follow the instructions for setup.

After you have completed the setup, you are ready to use your DVD-VCR.
Procedures differ depending on the hookup you used.

Before you get started

• Turn off the power to all equipment.
• Do not connect the AC power cords until all of the connections are completed. If

you connect the AC power cord before the connections are completed, you may not
be able to use the Plug and Play function.

• Be sure you make connections firmly. Loose connections may cause picture

distortion.

• If your TV does not match any of the examples provided, see your nearest Sony

dealer or qualified technician.

Caution

Connections between the DVD-VCR’s VHF/UHF connector and the antenna terminals of the
TV receiver should be made only as shown in the following instructions. Failure to do so may
result in operation that violates the regulations of the Federal Communications Commission
regarding the use and operation of RF devices. Never connect the output of the DVD-VCR to an
antenna or make simultaneous (parallel) antenna and DVD-VCR connections at the antenna
terminals of your receiver.

Note to CATV system installer (in USA)

This reminder is provided to call the CATV system installer’s attention to Article 820- 40 of the
NEC that provides guidelines for proper grounding and, in particular, specifies that the cable
ground shall be connected to the grounding system of the building, as close to the point of cable
entry as practical.

If you have

Use

Refer to

Antenna only, no cable TV

Hookup 1
(Plug and Play)

Pages 16 and 17

No cable box or cable box with only a
few scrambled channels

Hookup 2
(Plug and Play)

Pages 18 and 19

Cable box with many scrambled
channels

Hookup 3

Page 20