Shooting still images/movies – Sony DSC-T900 User Manual
Page 58
58
GB
The remaining charge indicator is incorrect.
•
The battery charge will get used up quickly and the actual remaining battery charge will be
lower than the indicator in the following cases:
–
When you use the camera in an extremely hot or cold location.
–
When you use the flash and zoom frequently.
–
When you repeatedly turn the power on and off.
–
When [Brightness] of the
(screen display) is set to [Bright].
•
A discrepancy arose between the remaining charge indicator and the actual remaining battery
charge. Fully discharge the battery pack once, then charge it to correct the indication.
•
The battery pack is discharged. Insert the charged battery pack (page 15).
•
The battery pack is dead. Replace it with a new one.
Cannot charge the battery pack while inside the camera.
•
You cannot charge the battery pack using the AC Adaptor (sold separately). Use the battery
charger (supplied) to charge the battery.
The CHARGE lamp flashes while charging the battery.
•
Remove and reinsert the battery pack, making sure it is installed correctly.
•
The temperature may be inappropriate for charging. Try charging the battery pack again
within the proper charging temperature range (10°C to 30°C (50°F to 86°F)).
Cannot record images.
•
Check the free capacity of the internal memory or “Memory Stick Duo” media (pages 31, 34).
If it is full, do one of the following:
–
Delete unnecessary images (page 39).
–
Change the “Memory Stick Duo” media.
•
You cannot record images while charging the flash.
•
Set the Mode switch to the correct mode.
•
Movies with the size set to [1280×720] can only be recorded on a “Memory Stick PRO Duo”
media. When using recording media other than “Memory Stick PRO Duo” media, set the
movie image size to [VGA].
•
The camera is in Smile Shutter demonstration mode. Set [Demo Mode] to [Off].
White, black, red, purple or other vertical streaks appear, or the whole screen of
the image becomes reddish when you are shooting a very bright subject.
•
This is called “smear phenomenon”. This is not a malfunction.
Shooting still images/movies