Sony DVP-NS9100ES - Manual (Page 27)

27
H
o
o
kups
: Connecting to the 5.1ch input jacks
You can enjoy 5.1ch surround sound using
the internal Dolby Digital, DTS, or Super
Audio CD Multi decoder of this player.
or : Connecting to a digital jack
This connection will allow you to use the
Dolby Digital, or DTS decoder function of
your AV amplifier (receiver).
z Hints
• For correct speaker placement, refer to the
instructions of the connected components.
• To enhance the sound performance:
–Use high-performance speakers.
–Use front, rear, and center speakers of the same
size and performance.
–Place the subwoofer between the left and right
front speakers.
Notes
• When the i.LINK indicator lights up, audio
signals are output from the i.LINK S200 AUDIO
jack, but not from any of the other jacks
(including HDMI OUT). Video signals are output
from the HDMI OUT jack.
For connection or
• After you have completed the connection, be sure
to set “DOLBY DIGITAL” to “DOLBY
DIGITAL” and “DTS” to “DTS” in Quick Setup
(page 33).
• When you connect an amplifier (receiver) that
conforms to the 96 kHz sampling frequency, set
“48kHz/96kHz PCM” in “AUDIO SETUP” to
“96kHz/24bit” (page 82).
• Super Audio CD audio signals are not output from
the DIGITAL OUT (COAXIAL or OPTICAL)/
HDMI OUT jack.
• When you connect the player to an AV amplifier
(receiver) using an HDMI cord, you will need to
do one of the following:
–Connect the AV amplifier (receiver) to the TV
with the HDMI cord.
–Connect the player to the TV with a video cord
other than HDMI cord (component video cord, S
VIDEO cord, or audio/video cord).
• When the i.LINK indicator lights up, no signal is
output from the DIGITAL OUT (COAXIAL or
OPTICAL)/ HDMI OUT jack.
D-1
D-2 D-3
D-2 D-3
c continued