Charging the battery pack using your computer, Charging time, To remove the battery pack – Sony HDR-PJ790V User Manual
Page 51: Adaptor (soldseparately), Handycam" user guide
Search
Saving images with an external
device
Top page > Getting started > Charging the battery pack > Charging the battery pack using your
computer
Charging the battery pack using your computer
1.
Turn off your camcorder and connect the camcorder to a running computer using the Built-in USB
Cable (
).
: To the wall outlet (wall socket)
The CHG (charge) lamp turns on.
The CHG (charge) lamp turns off when the battery pack is fully charged. Disconnect Built-in USB
Cable from your computer.
To charge the battery using an AC-UD10 USB charger/AC Adaptor (sold
separately)
You can charge the battery by connecting the Built-in USB Cable to a wall outlet (wall socket) using an
AC-UD10 USB charger/AC Adaptor (sold separately). You cannot use a Sony CP-AH2R, CP-AL, or AC-
UP100 portable power supply device (sold separately) to charge the camcorder.
Charging time
Approximate time (min.) required to fully charge a fully discharged battery pack.
Battery pack
Built-in USB Cable* (when using your computer)
NP-FV50 (supplied) 280
NP-FV70
545
NP-FV100
1,000
The charging times shown in the table above are measured when charging the camcorder at a room
temperature of 25 °C (77 °F). It is recommended that you charge the battery in a temperature range
of 10 °C to 30 °C (50 °F to 86 °F).
* The charging times are measured without using the USB Connection support cable.
To remove the battery pack
Close the LCD screen. Slide the BATT (battery) release lever (
) and remove the battery pack (
).
42