During infrared communication, Picturegear pocket, Inches – Sony PEG-S320 User Manual
Page 29
During Infrared communication
Cannot find receiver's CLIE Handheld.
Cause
When [Beam Receive] in Preferences is turned off or the distance or the direction of the receiving
CLIE handheld is too far IR Communication is impossible.
The following message appears on the sender's CLIE handheld during Infrared communication'.
Solution
Turn [Beam Receive] on for the receiving handheld. Tap the "Preferences" icon of [Home] to open
[Preferences]. In the drop-down menu, select "General" and turn [Beam Receive] on.
Solution
When [Beam Receive] is on, confirm that the IR port of the sender and the receiver are placed within
rare to communicate each other.
In other words, both the IR ports have to face each other at 4 ~ 8 inches (10 ~ 20 cm) without any
obstacles. The optimal data transfer distance may differ depending on the operational relation
between the CLIE handheld and your computer, or devices other than Sony. Change the distance and
try the procedure again.
The battery consumption is a little higher when "Beam receive" is left on.
Cannot locate the receiver 's PictureGear application.
Cause
When the following warning dialog is displayed on the receiver's CLIE handheld, PictureGear Pocket
is not installed on the receiver's CLIE handheld.
Solution
Install PictureGear Pocket on the receiver's CLIE handheld.
Cannot HotSync.
After connecting the line, you cannot perform HotSync operation with your computer.
Cause
You cannot perform HotSync operation when the line is still connected after using communication
software such as Palmscape or CLIEMail.
Solution
Disconnect the line. To disconnect the line, change to "Network" in the upper-right drop-down menu of
the "Preferences" screen, and then tap the "disconnect" button.
5.2
PictureGear Pocket
Warning dialog
Warning dialog
4~8
inches
Receiving
Side
Sending
Side