beautypg.com

Installation, Warning indicator, Powering off the projector – Acer PW730 User Manual

Page 14

background image

English ...

Installation

Warning Indicator

When the “

LAMP” indicator lights solid amber, the projector

will automatically shut itself down. Please contact your local

reseller or service center.

When the “TEMP” indicator lights solid amber, it indicates the

projector has been overheated. You will see a message “Projector

Overheated. Lamp will automatically turn off soon.” on the on-

screen display. The projector will automatically shut itself down.

Under normal conditions, the projector can be switched on again

after it has cooled down. If the problem persists, you should con-

tact your local dealer or our service center.

When the “TEMP” indicator flashs amber, you will see a mes-

sage “Fan fail. Lamp will automatically turn off soon.” on the

on-screen display. Please contact your local dealer or our service

center.

Powering Off the Projector

1. Press the “Power” button to turn off the projector lamp, you will

see a message “Please press power button again to complete the

shutdown process. Warning: DO NOT unplug while the projector

fan is still running.” displayed on the projector’s screen. Press

the “Power” button again to confirm, otherwise the message will

disappear after 5 seconds.

2. The cooling fans continue to operate for about 120 seconds for

cooling cycle and the Power LED will be quick

amber flash

.

When the Power LED becomes slow flashing, the projector has

entered standby mode. If you wish to turn the projector back on,

you must wait until the projector has completed the cooling cycle

and has entered standby mode. Once in standby mode, simply

press “Power” button to restart the projector. It may not restart

successfully at the first time, the projector will automatically

restart till success. Do not need to press “Power” button to turn on

the projector during this period.

3. Disconnect the power cord from the electrical outlet and the

projector.

4. Do not turn on the projector immediately following a power off

procedure.

5. Close the lens cap to prevent dust if you like.