Acer PW730 - Manual (Page 13)

... English
Installation
Powering On/Off the Projector
Power
Powering On the Projector
1. Open the lens cap.
2. Ensure that the power cord and signal cable are securely
connected. The Power LED will flash amber.
3. Turn on the lamp by pressing “Power” button on the control
panel  and the Power LED will turn amber.
4. Turn on your source (computer, notebook, video player
,etc.). The projector will detect your source automatically.

If the screen displays ”Lock” & ”Source” icons, it means the pro-
jector locks on this source type and there is no such type of input
signal found.
 If the screen displays “No Signal”, please make sure the signal
cables are securely connected.
 If you connect multiple sources at the same time, using the
“Source” button on the remote control or control panel to switch.
 Turn on the
projector first and
then the signal
sources.
 The lens cap must
be opened then
turn on the projec-
tor.
r If the projection lens cap is not opened when a projector is powered
on, users will hear a continuous beep sound, and the interval of each
beep warning message is about 3 seconds.
r The projector will not be turned on and automatically go to stand-by
mode if the lens cap is still closed after beep sound keeps warning for
5 times.
r If the projection lens cap is accidentally closed while the projector is
running, users will hear the same beep sound and the projector will
automatically go to stand-by mode if the lens cap is still not opened
after 5 times of warning sound.
1