Sony RDP-XA900iPN - Manual (Page 20)

16 US
Listening to iPod
1
Press the “iPod” button.
2
Press the Docking Tray on the
front of the unit to open it.
3
Set your iPod on the Docking
Tray.
Tip
If a pop-up message appears on the display of
the iPod, refer to “AirPlay via Wi-Fi Network
Setup” or see “About D-Sappli” (page 17).
4
Press the u button.
The iPod begins to play back. You can
operate the connected iPod via this unit or
the iPod itself.
Notes
• Remove the case or cover from your iPod before
setting in the Docking Tray if a good connection
cannot be ensured.
• When placing or removing the iPod, hold the iPod
at the same angle as that of the connector of the
Docking Tray. Do not twist or bend the iPod as it
may damage the connector.
• Do not carry the unit with an iPod set on the
Docking Tray. Doing so may cause a malfunction.
• When placing or removing the iPod, hold the
Docking Tray securely.
• Before disconnecting the iPod, pause playback.
• If the battery of your iPod is extremely low, charge
it for a while before operation.
• Sony cannot accept responsibility in the event that
data recorded to an iPod is lost or damaged when
using an iPod connected to this unit.
• For details of environmental conditions for
operating your iPod, check the website of Apple
Inc.
To use the unit as a battery
charger
You can use the unit as a battery charger. The
charging status appears in the “iPod” display.
For details, see the user’s guide of your iPod.
When the unit is in standby mode, the battery
may not be charged, even if you connect the
iPod to the Dock connector. In this case, turn
on the unit.
Enjoying the Audio Content