Sony VPL-HS3 - Manual (Page 16)

Con
n
ect
ions a
n
d
P
repar
ati
o
n
s
GB
16
Step 3: Adjusting the Picture Size and Position
5
Adjust the focus using the
FOCUS ring, and adjust the
picture size using the ZOOM
ring.
6
Adjust the position of the
picture to fit the screen using
the adjuster.
Adjusting the picture position using
the adjuster
Hold down and slide the adjuster lock lever to the
right, move the projector, then return the lock lever.
You can move the projector horizontally or vertically
within the following ranges:
To reset the projector to the center position
of the adjuster
Hold down and slide the adjuster lock lever to the
right, move the projector, then return the lock lever
until the adjuster clicks into the round hole in the
lower side at the rear of the projector with a click.
Adjusting the picture position using
the supplied adjuster spacer
Attaching one of the supplied spacers for adjuster
adjustment (spacers for 1
º and 2 ° ) allows you to tilt
the projector to the right or left at a tilting angle up to
2
º .
To attach the supplied adjuster
spacer
1 Place a thick cloth (e.g., a cushion)
beneath the projector. Place the projector
face down.
2 While pressing the lock knobs inward,
remove the adjuster bar at the bottom of
the adjuster table to which you want to
attach the supplied spacer.
3 Fit the spacer into the removed adjuster
bar spot.
FOCUS ring ZOOM ring
Adjuster lock lever
Up to 30° each
way horizontally
Up to 10° each way
vertically
Round
hole
Adjuster spacer
(supplied)
Adjuster spacer (supplied)