AEG CG 6400 User Manual

Page 29

The coffee runs out too quickly

• The coffee is ground too coarsely.

0 Turn the knob for setting grinding tex-

ture one click anticlockwise (see „Set-
ting the grinding texture“, page 46).

The coffee flows out of only one of
the dispensers

• The dispenser holes are blocked.

0 Scrape off the dry coffee residues with

a needle (Fig. 29).

When the knob for steam and hot
water is turned, no steam comes out
of the steam nozzle

• The holes in the steam nozzle and the

inner part of the steam nozzle are
clogged.

0 Clean the holes in the steam nozzle

and the inner part of the steam nozzle
(see „Cleaning the steam nozzle“,
page 45).

When the

function is

selected, the appliance does not
deliver coffee, but only water

• The ground coffee may be blocked in

the ground coffee filler.

0 Remove the ground coffee inside the

filler using a knife (see „Using pre-
ground coffee“, page 43) (Fig. 22). Then
clean the brewing unit and the inside
of the appliance (see „Cleaning the
brewing unit“, page 51)

When the button

is pressed, the

appliance does not switch on

• The main switch at the back is not

switched on (fig. 8) or the appliance is
not plugged in.

0 Check that the main switch is in the "I“

position and that the power cable is
plugged into the mains socket.

The brewing unit cannot be removed
for cleaning

• The appliance is on. The brewing unit

can only be removed if the appliance is
off.

0 Turn the appliance off and remove the

brewing unit (see „Cleaning the brew-
ing unit“, page 51).

Important: The brewing unit can only
be removed if the appliance is turned
off with the ON/OFF key

at the

front. It should not be disconnected
from the mains. Attempting to
remove the brewing unit when the
appliance is on may cause serious
damage.

The coffee does not run out from
the dispenser outlets, but from
around the sides of the service door

• The holes in the dispenser outlets are

clogged with dry coffee.

0 Remove the dried coffee with a needle

(Fig. 29).

• The tilt compartment (R) inside the ser-

vice door is blocked and cannot swing.

0 Thoroughly clean the tilt compartment,

particularly near the hinges, to ensure
they are free to swing smoothly.

Ground coffee was used (not beans)
and the appliance does not deliver
any coffee

• Too much ground coffee has been

added.

0 Remove the brewing unit and thor-

oughly clean the inside of the appli-
ance, as described in „Cleaning the
brewing unit“, page 51. Repeat the
operation using a maximum of 2
scoops of ground coffee.

• The "Coffee strength / Pre-ground cof-

fee" knob has not been turned to the

position and the appliance

has used both the ground coffee that
has been added and the coffee that has
been ground by the grinder.

0 Thoroughly clean the inside of the

appliance, as described in „Cleaning
the brewing unit“, page 51. Repeat the
operation, first turning the "Coffee
strength / Pre-ground coffee" knob as
described in „Using pre-ground cof-
fee“, page 43.

• Ground coffee has been added when

the appliance was switched off.

822_949_344 CG6400.book Seite 55 Mittwoch, 25. Oktober 2006 12:38 12