AEG CG 6400 - Manual (Page 12)

g
38
6.2 Filling with water
Each time before switching on the cof-
fee machine, check that there is water
in the water tank, and refill if neces-
sary. The coffee machine requires water
for the automatic rinsing processes
each time the machine is switched on
or off.
0 Remove the water tank from the cof-
fee machine (Fig. 6). Before the tank is
removed, the steam nozzle must
always be positioned towards the cen-
tre of the appliance, otherwise the
tank cannot be removed.
0 Fill the water tank with fresh cold
water. Never exceed the MAX line.
3 Pour only fresh cold water into the
water tank. Never put in other liquids,
e.g. mineral water or milk.
0 Replace the water tank (Fig. 6). Press
the tank firmly in, to ensure that the
water tank valve opens.
3 To always be sure of obtaining a rich
coffee with a full aroma, you should:
– change the water in the water tank
daily,
– wash the water tank at least once a
week in normal washing-up water
(not in the dishwasher). Then rinse
with fresh water.
6.3 Filling the coffee bean container
0 Raise the lid of the coffee bean con-
tainer, and fill the container with fresh
coffee beans (Fig. 7). Then reclose the
lid.
1 Note! Make sure that no foreign
objects, such as stones, enter the cof-
fee bean container. Damage caused by
foreign objects in the grinder is
excluded from the guarantee.
3 The grinder is factory-set to a medium
grinding texture. If necessary, you can
change this setting. Notes on changing
the grinder setting can be found in
„Setting the grinding texture“,
page 46.
1 The grinder settings may be changed
only whilst coffee is being ground.
Making adjustments to the stationary
grinder can damage the coffee
machine.
3 Coffee has been used to factory-test
the appliance, and it is therefore com-
pletely normal for there to be traces of
coffee in the mill. This appliance is
however guaranteed to be new.
6.4 Switching on for the first time
When you operate the machine for the
first time, the automatic switching on
process only continues if you have
selected the desired language.
0 Switch on the machine with the main
switch on the rear of the machine
(Fig. 8).
The display shows the text «PRESS
MENU TO CHOOSE ENGLISH»
successively in all available languages.
0 Wait for the correct language and
press the "Menu" key to confirm
(Fig. 4) and keep it pressed until the
display shows: «ENGLISH INSTAL-
LED».
3 After using the machine for the first
time you can change the language at
any time; see „Setting the language“,
page 46.
After programming the language, the
display shows «FILL TANK !».
0 Fill the water tank; see „Filling with
water“, page 38.
0 Replace the water tank (Fig. 6). Press
the tank firmly in, to ensure that the
water tank valve opens.
The display now shows:
«TURN STEAM KNOB»
0 Move the steam nozzle outwards and
place a cup underneath it (Fig. 9).
0 Turn the knob for steam and hot water
anticlockwise as far as it will go to the
position
(Fig. 10).
After a few seconds, a little water runs
out of the steam nozzle and the display
shows a progress bar. When the cup
contains about 30 ml of water, the
822_949_344 CG6400.book Seite 38 Mittwoch, 25. Oktober 2006 12:38 12