beautypg.com

Hardware setup – Asus A7VL133-VM User Manual

Page 32

background image

32

ASUS A7VL133-VM User’s Manual

Connectors

3. H/W SETUP

3. HARDWARE SETUP

12) Standard and Consumer Infrared Module Connector (5 pin IR)

This connector supports an optional wireless transmitting and receiving infrared
module. This module mounts to a small opening on system cases that support
this feature. You must also configure the setting through UART2 Use Infrared
(see 4.4.2 I/O Device Configuration) to select whether UART2 is directed for
use with COM2 or IrDA. Use the five pins as shown in Back View and connect
a ribbon cable from the module to the motherboard’s SIR connector according
to the pin definitions.

A7VL133-VM

®

A7VL133-VM Infrared Module Connector

Front View

Back View

+5V

IRTX

IRRX

(NC)

GND

IR

+5V

IRRX

IR

TX

GND

1

11) Floppy Disk Drive Connector (34-1 pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connect-
ing the single end to the board, connect the two plugs on the other end to the
floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta-
tion when using ribbon cables with pin 5 plugged).

NOTE: Orient the red markings on
the floppy ribbon cable to

PIN 1

A7VL133-VM Floppy Disk Drive Connector

PIN 1

A7VL133-VM

®