Sony MHC-RG4SR - Manual (Page 11)

11
CD
To Do this
Switch to CD
function from
another source
3
Press one of DISC 1 – 3 to select a CD.
To program all the tracks on a CD at once,
proceed to step 5 with “AL” displayed.
4
Press . or > until the desired
track appears in the display.
Disc tray number
Total playing time
(including selected track)
Track number
5
Press ENTER on the remote.
The track is programed. The program step
number appears, followed by the total
playing time.
6
Program additional discs or tracks.
To program Repeat steps
Press DISC 1 – 3 (Automatic
Source Selection). However, if a
CD is used in a program, play does
not start even if you press CD 1 –
3.
Remove a CD Press Z OPEN/CLOSE.
Exchange other
CDs while
playing Press DISC SKIP EX-CHANGE.
Play repeatedly
(Repeat Play) Press REPEAT on the remote
during play until “REP” or “REP
1” appears.
REP*: For all the tracks on the CD
up to five times.
REP 1**: For a single track only.
To cancel playing repeatedly, press
REPEAT until “REP” or “REP 1”
disappears.
* You cannot select “REP” and “ALL DISCS
SHUF” at the same time.
** When you select “REP 1”, that track is repeated
endlessly until “REP 1” is canceled.
Note
The play mode cannot be changed while playing a
disc. To change the play mode, press x first to stop
play.
Programing CD tracks
— Program Play
You can make a program of up to 32 tracks
from all the CDs in the order you want to play
them.
1
Press CD, then place a CD.
2
Press PLAY MODE on the remote
repeatedly until “PGM” appears in the
display.
Other discs 3 and 5
Other tracks on the
same disc 4 and 5
Other tracks on other
discs 3 to 5
7
Press H (or N on the remote).
Other Operations
To Do this
Cancel Program
Play Press PLAY MODE on the
remote repeatedly until “PGM”
and “SHUF” disappear.
Clear a track from
the end Press CLEAR on the remote in
stop mode.
Clear the entire
program Press x once in stop mode or
twice during play.
continued