Sony WHG-SLK1I - Manual (Page 86)

WHG-SLK2i/WHG-SLK1i.GB.4-187-068-11(1)
GB
The system has entered standby
mode unexpectedly.
 This is not a malfunction. The system
enters standby mode automatically
after about 30 minutes when there is
no operation, or when playback ends
on the connected device. See “To turn
off the automatic standby function”
(page 97).
The clock or timer setting is
cancelled.
 The power cord is disconnected or a
power failure occurred. Redo “Setting
the clock” (page 30). If you have set
the timer, redo “Using the timers”
(page 76).
There is no sound.
 Press VOLUME + (or VOL + on the
unit) repeatedly.
 The headphones are connected to the
PHONES jack.
 Check the speaker connections
(page 24).
 The system is in pause mode, in Slow-
motion Play or in Lock Search. Press
 to start the playback.
There is severe hum or noise.
 A TV or VCR is placed too close to the
unit. Move the unit away from the TV
or VCR.
 Move the unit away from the source of
noise.
 Install a noise filter (commercially
available) to the power cord.
The timer does not function.
 Check the timer setting and set the
correct time (page 76).
 Cancel the Sleep Timer function.
The remote does not function.
 Remove the obstacles between the
remote and the unit.
 Move the remote closer to the unit.
 Point the remote at the unit’s sensor.
 Replace the batteries (R6/size AA).
 Locate the unit away from the
fluorescent light.
There is acoustic feedback.
 Reduce the volume.