beautypg.com

Message lists, Warning messages caution messages message lists – Sony VPL-HW15 User Manual

Page 64

background image

64

Warning messages

Caution messages

Message Lists

Message

Cause and Remedy

High temp.! Lamp off in 1
min.

c Turn off the power.
c Check to ensure that nothing is blocking the ventilation holes.

(

1 page 12)

Frequency is out of range!

c Frequency is out of range. Input a signal that is within the

acceptable frequency range of the projector. (

1 page 72)

Please check Input-A
Signal Sel.

c Set “Input-A Signal Sel.” in the Setup

menu to

“Computer” when an RGB signal is input from a computer.
(

1 page 51)

Please replace the Lamp/
Filter.

c It is time to replace the lamp. Replace the lamp. (1 page 65)
c Also, replace the air filter too. Restart cleaning the ventilation

holes (intake). (

1 page 65)

If this message appears again after you replace the lamp and
filter, the lamp replacement process is not complete. Check the
lamp replacement process. (

1 page 65)

To clear this message, press any button either on the remote control
or the control panel of the projector once.

Please clean the filter.

c It is time to clean the air filter. Clean the air filter. (1 page 68)

To clear this message, press any button either on the remote control
or the control panel of the projector once.

Please clean the filter. Have
you finished? Yes No

c It is time to clean the air filter. Clean the air filter. (1 page 68)
c If you cleaned the air filter, select “Yes.” If you did not clean the

air filter, select “No.”

Projector temperature is
high. Cooling Setting
should be “High” if
projector is being used at
high altitude.

c Check to ensure that the ventilation holes on the unit are not

covered. (

1 page 12)

c When using the projector at high altitude, set the Cooling

Setting to “High”. (

1 page 50)

When temperature inside the projector remains high, the Cooling
Setting is switched to “High” in 1 minute, then the fan speed
increases.

Message

Cause and Remedy

c No signal is input in the selected input. Check connections.

(

1 page 22)

Not applicable!

c Press the appropriate button.
c The operation to be activated by the button is currently

prohibited.

Note

Note

Note

x