Sony RDH-SK8iP - Manual (Page 14)

model name [RDH-SK8iP]
[4-166-642-12(1)] GB
14 GB
filename[D:\NORM'S JOB\SONY HA\SO0080\RDH-SK8iP\GB\GB06ADD.fm] masterpage:Left
7
Place back the “L” ring by
matching the “b L” on the ring
with “L B” on the acrylic plate.
Then, turn the ring in the
“LOCK” arrow direction until it
locks.
Notes
• Make sure the rib of the ring is horizontally
parallel after you place back the ring.
Otherwise, the ring is not attached to the front
panel securely.
• Make sure the “R” ring is attached to the right
of the front panel and the “L” ring is attached
to the left of the front panel.
You can also create your own graphic
sheet. Prepare the paper material (posters,
newspapers, printing, handmade graphic
arts, etc.).
After you have prepared the paper
material, we recommend you to use the
acrylic plate as a template to draw the
outline of the custom graphic sheet. Then,
trim the graphic sheet according to the
outline.
Troubleshooting
Should you encounter a problem with
your unit, do the following:
1 Make sure the AC power cord
(mains lead) is connected correctly
and firmly.
2 Find your problem in the
troubleshooting checklist below and
take the indicated corrective action.
If the problem persists after doing all of
the above, consult your nearest Sony
dealer.
Note that if service personnel changes
some parts during repair, these parts may
be retained.
Customizing the graphic sheet
L L
L O C K
“L” ring
Acrylic plate
When the indicator does not stop
flashing
Immediately turn off the unit and
unplug the AC power cord (mains
lead).
Then perform the following items.
• Remove anything that is blocking
the ventilation hole.
• Disconnect the iPod/iPhone.
• Disconnect audio cord from the
AUDIO IN jack.
After performing the above items and
fixing any problems, plug in the AC
power cord (mains lead) again and
turn on the unit. If the indicator still
flashes, or if the cause of the problem
cannot be found even after performing
all the above items, consult your
nearest Sony dealer.