beautypg.com

Altering an option or a running programme, Interrupting a programme, Cancelling a programme – AEG 73742 User Manual

Page 15: Opening the door after the programme has started, At the end of the programme

background image

Selecting the delayed start.
• Select the programme and the required options.
• Select the delay start.
• Press button 7: the appliance starts its hourly countdown. The programme will start after

the selected delay has expired.

Cancelling the delayed start
• Set the washing machine to PAUSE by pressing the button 7;
• Press button 8until the symbol ’ is displayed;
• Press the button 7 again to start the programme.
The selected delay can be changed only after selecting the washing programme again.

The Delay Start can not be selected with Drain programme.

Altering an option or a running programme

It is possible to change some options before the programme carries them out. Before you

make any change, you must pause the washing machine by pressing the button 7.

Changing a running programme is possible only by resetting it. Turn the programme selec-
tor dial to

and then to the new programme position. Start the new programme by

pressing the 7 button again. The washing water in the tub will not emptied out.

Interrupting a programme

Press the button 7 to interrupt a programme which is running, the corresponding light

starts blinking. Press the button again to restart the programme.

Cancelling a programme

Turn the selector dial to to cancel a programme which is running. Now you can select a

new programme.

Opening the door after the programme has started

First set the machine to pause by pressing the button 7.
• If the DOOR symbol disappears, the door can be opened;
• If the DOOR symbol doesn’t go off, it means that the machine is already heating, that the

water level is above the bottom edge of the door. In this case the door cannot be

opened;

• If you cannot open the door but you need to open it, you have to switch the machine off

by turning the selector dial to

. After some minutes the door can be opened (pay

attention to the water level and temperature!);

After closing the door, it is necessary to select the programme again and to press button 7.

At the end of the programme

The machine stops automatically, the pilot light of button 7 pilot light goes off, a blinking

appears on the display and the acoustic signal sounds for some minutes.

If you have chosen a programme or an option that ends with water in the tub, follow the

below instruction to empty the water out:

Daily use

15