Sony RM-NX7000 - Manual (Page 3)

3
Overview
JPEG VIEWER is an application to view JPEG files in a “Memory Stick,” and
create a screen saver on the RM-NX7000 remote control.
JPEG files to be used
The following JPEG file specifications are required to run RM-NX7000:
• Memory capacity for start-up: 5 MB* or more
• Format: JFIF (JPEG File Interchange Format) compliance
Non support for Progressive JPEG and Multi-scan JPEG files
• Pixel count: 3,264
×
2,448 pixels, 2,448
×
3,264 pixels or lower
• File size: 5 MB or less
(Viewable file size varies depending on the free space on your
RM-NX7000)
• File name: English one-byte characters and symbols below
! # $ % & ’ ( ) + – . ; = @ [ ] ^ _ { } ˜
• Maximum file name: Up to 32 characters (not including a file extension)
• File extension: jpg, jfi, jif, jpe, jpeg, jfif
• Directory name: English one-byte characters and symbols below
! # $ % & ’ ( ) + – . ; = @ [ ] ^ _ { } ˜
• Maximum directory tree: UP to 128 characters by the full pathname of
directories (including drive name and path separator)
• Viewable file/directory number: 4,000 files/directories in “Memory
Stick”
• Maximum file/directory number: 8,000 files/directories in “Memory
Stick”
If files/directories are over 8,000, the application will not work properly.
Design and specifications are subject to change without notice.
* If 5 MB of memory is not available, the message appears shown below:
“The Remote Commander memory is insufficient. Quit JPEG Viewer.”