Sony SRS-D2100 - Manual

VOLUME BASS PHONE
ON OFF POWER
MIN MAX
B
 2004 Sony Corporation Printed in China
Operating Instructions
Manual de instrucciones
Active Speaker System
SRS-D2100
3-264-412-11(1)
POWER
VOLUME
Owner’s Record
The model number and the serial number are located on the rear of the
subwoofer.
Record the model number and the serial number in the space provided below.
Refer to them whenever you call upon your Sony dealer regarding this product.
Model No. SRS-D2100
Serial No.
to wall outlet
D
* “WALKMAN” is a registered
trademark of Sony Corporation to
represent Headphone Stereo products.
CD/MD
Walkman*, etc
PC, etc.
On operation
• Do not drive the speaker system with a continuous
wattage exceeding the maximum input power of the
system.
• Before connecting, turn off the speaker system, the
PC and audio component to avoid damaging the
speaker system.
• The volume level should not be turned up to the
point of distortion.
• Although this system is magnetically shielded, do not
leave recorded tapes, watches, personal credit cards
or floppy disks using magnetic coding in front of the
system for an extended period of time.
If the TV picture or monitor display is
magnetically distorted
Although this system is magnetically shielded, there may
be cases that the picture on some TV sets/personal
computers may become magnetically distorted. In such a
case, turn off the power of the TV set/personal computer
once, and after 15 to 30 minutes turn it on again. In the
case of a personal computer, take appropriate measures,
such as data storage, before turning it off.
When there seems to be no improvement, locate the
system farther away from the TV set/personal
computer. Furthermore, be sure not to place objects in
which magnets are attached or used near the TV set/
personal computer, such as audio racks, TV stands, toys
etc. These may cause magnetic distortion to the picture
due to their interaction with the system.
On placement
• Do not set the speakers in an inclined position.
• Do not leave the system in a location near heat
sources, or in a place subject to direct sunlight,
excessive dust, moisture, rain or mechanical shock.
• Do not install the satellite speaker anywhere other
than on a wall.
• Do not hang on the satellite speaker or hang anything
on it.
On cleaning
Do not use alcohol, benzene, or thinner to clean the
cabinet.
If you have any questions or problems concerning your
speaker system, please consult your nearest Sony
dealer.
to Front R jack to Front L jack
to 8-pin Din jack
Subwoofer (rear)
Control Box
(rear)
to LINE OUT or
headphones jack
(stereo mini-jack)
PHONES
C
Control box
English
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
WARNING
To prevent fire or shock hazard, do not expose the
unit to rain or moisture.
To avoid electrical shock, do not open the cabinet. Refer
servicing to qualified personnel only.
To prevent fire, do not cover the ventilation of the
apparatus with news papers, table-cloths, curtains, etc.
Do not place lighted candles on the apparatus.
To prevent fire or shock hazard, do not place objects
filled with liquids, such as vases, on the apparatus.
Do not install the appliance in a confined space,
such as a bookcase or built-in cabinet.
CAUTION
You are cautioned that any changes or modification not
expressly approved in this manual could void your
authority to operate this equipment.
NOTICE FOR THE CUSTOMERS IN THE USA
This symbol is intended to alert the user to
the presence of uninsulated “dangerous
voltage” within the product’s enclosure
that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
This symbol is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the appliance.
Precautions
On safety
The nameplate indicating operating voltage, power
consumption, etc., is located on the rear exterior.
• Before operating the system, be sure that the
operating voltage of the system is identical with that
of your local power supply.
Where purchased Operating voltage
U.S.A./Canada 120 V AC, 60 Hz
European countries 220 – 230 V AC, 50 Hz
Other countries • 110 – 120 V AC, 50/60 Hz
• 220 – 230 V AC, 50 Hz
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet, even if the unit itself has been turned off.
• Unplug the system from the wall outlet if it is not to
be used for an extended period of time. To disconnect
the cord, pull the cord by grasping the plug. Never
pull the cord itself.
• Should any liquid or solid object fall into the system,
unplug the system’s power cord and have the system
checked by qualified personnel before operating it
any further.
• The AC power cord should be changed only at a
qualified service shop.
• For efficient heat dissipation, ensure there is sufficient
space to the rear of the subwoofer. Also, avoid
placing objects on the unit.
• Do not insert your hand or any objects into the hole of
the subwoofer.
to INPUT2 jack
to LINE OUT or
headphones jack
Connecting
Cable
(supplied)
to INPUT1 jack
Subwoofer (1) Control box (1) Connecting Cable (1)
Satellite speaker (2) Base (2) Screw (2)
A
,
A
B
,
Satellite speaker
Satellite speaker
Base
Base
Screw
Screw
Hollow wall anchors
(ø 4 mm, not supplied)
Anchor holes
Package Contents
PC, CD or MD
Walkman, etc.
Front speaker (Left)
Subwoofer
Control box
Front speaker (Right)
Installing the satellite speakers
(See fig. A)
Use the supplied screws to attach the base to the
satellite speaker. The satellite speaker can be used either
placed on a desk or attached to a wall.
When you use the satellite speaker on a desk
(See fig. A-A)
By attaching the base to the satellite speaker, it can be
placed on a desk.
1 Match the hole of the base and the
bottom hole of the satellite speaker.
Attach the base with the anchor holes facing
forward.
The base allows you to adjust the satellite speaker
to the desired angle.
2 Ensure the screws are tight.
Tighten the screw with your finger. If it is difficult,
use a screwdriver to secure the screw.
When you use the satellite speaker attached
to a wall (See fig. A-B)
By attaching the base to the satellite speaker, it can be
attached to a wall. Follow the Notes (below) to install
safely. Improper installation may result in the speaker
falling and causing bodily injury or damage to the
speaker or other object.
1 Align the hole in the base with the hole
at the rear of the satellite speaker.
Attach the base with the anchor holes uppermost.
The base allows you to adjust the satellite speaker
to the desired angle.
2 Ensure the screws are tight.
Tighten the screw with your finger. If it is difficult,
use a screwdriver to secure the screw.
3 Secure the hollow wall anchor in the wall
— refer to the illustration.
Notes
• Confirm wall thickness is sufficient. A
minimum thickness of 9.5 mm is recommended
for plasterboard.
• Use the specified clamp (hollow wall anchor,
not supplied) when attaching to plasterboard.
• Refer to the supplied operating instructions
using a hollow wall anchor.
• Use wall anchors of at least 20 kg hanging
capacity.
• Refer to the instruction supplied with hollow
wall anchor.
• Requires ø 4 mm hollow wall anchor.
• Set up the head of a hollow wall anchor 5 mm
from the wall.
• Apply a bond (anaerobic threadlocking
material) to the hollow wall anchor to prevent
the screw loosening.
4 Attach the satellite speaker to the wall.
Insert both wall anchors in the anchor holes of the
satellite speaker base.
Note
Ensure that the satellite speaker is securely
attached to the wall before use.
Hooking up the system
(See fig. B)
1 Connect the cord of the control box to
the 8-pin Din jack of the subwoofer with
their respective arrows aligned.
2 Connect the satellite speakers to the
subwoofer.
Confirm the location of the satellite speakers, and
then connect to their respective jacks.
3 Connect the control box to the source
equipment.
– PC, etc.:
Connect the INPUT1 jacks of the control box and
the LINE OUT or headphones jack of a PC, etc.
with the supplied connecting cord. For details,
refer to the operating instructions of the PC.
– CD/MD Walkman, etc.:
Connect the INPUT2 jack of the control box and
the LINE OUT or headphones jack of a CD/MD
Walkman, etc. The connecting cord is not supplied
with this system.
Note
To switch INPUT1 and INPUT2, use ON/OFF of
the device connected to the control box.
4 Connect the subwoofer to the wall
outlet.
5 Position the speakers. (See fig. C)
Listening to the sound (See fig. D)
First, turn down the volume on the control box. The
volume should be set to minimum before you begin
playing the programme source.
1 Set the POWER switch to ON on the
control box.
The POWER indicator lights up.
2 Adjust the VOLUME control on the
control box.
You can adjust the volume of the subwoofer and
each satellite speaker.
When connecting to the headphone output, also
adjust the volume of the connected component.
After listening, set the POWER switch to OFF.
The POWER indicator goes off.
3 Using headphones/earphones.
Connect headphones/earphones to the PHONES
jack on the control box.
Note
Turn off the MEGA BASS or BASS BOOST
(Walkman, etc.) function as it may cause audible
distortion.
40 mm
Troubleshooting
Should you encounter a problem with your speaker
system, check the following list and take the indicated
measures. If the problem persists, consult your nearest
Sony dealer.
There is no sound from the speaker system.
• Make sure all the connections have been correctly
made.
• Make sure the VOLUME dial and the each speaker’s
volume dial on the control box.
• Make sure the connected component has been turned
up properly.
• Check if headphones are connected. If they are,
disconnect them.
The sound is distorted.
• Turn down the volume level on the connected
component. Or, if the connected component has a
BASS BOOST function, set it to off.
• Rotate BASS on this unit to reduce the bass volume.
• Turn VOLUME on this unit down to reduce the
volume.
There is hum or noise in the speaker output.
• Make sure all the connections have been correctly
made.
• Make sure none of the audio components are
positioned too close to the TV set.
The sound has suddenly stopped.
Make sure all the connections have been correctly made.
The brightness of the POWER indicator is
unstable.
The brightness of the POWER indicator may become
unstable when the volume is turned up. This is not a
malfunction.
Specifications
Speaker section
Satellite speaker
Speaker system Full range, magnetically shielded
Speaker units 5.6 cm, cone type
Enclosure type Closed type
Impedance 6 Ω
Cord length 3 m
Subwoofer
Speaker system Woofer
Speaker units 16 cm, cone type
Enclosure type Bass reflex
Impedance 6 Ω
Amplifier section
Rated output 12 W (10% T.H.D., 1 kHz, 6 Ω )
(Satellite speaker)
80 W (10% T.H.D., 100 Hz, 6
Ω )
(Subwoofer)
Input Stereo mini jack × 1 (INPUT 1)
Stereo mini jack × 1 (INPUT 2)
Input impedance 4.7 k Ω (at 1 kHz)
Output Stereo mini jack × 1 (PHONES)
General
Dimensions (w/h/d) Approx. 130 Ч 40 Ч 73 mm
(5 1 / 8 Ч 1 5 / 8 Ч 2 7 / 8 in.) (Control box)
Approx. 95 Ч 135 Ч 150 mm
(3 3 / 4 Ч 5 3 / 8 Ч 6 in.) (Satellite speaker,
on a desk)
Approx. 95
Ч 100 Ч 180 mm
(3 3 / 4 Ч 4 Ч 7 1 / 8 in.) (Satellite speaker,
attached to a wall)
Approx. 285
Ч 285 Ч 462 mm
(11 1 / 4 Ч 11 1 / 4 Ч 18 1 / 4 in.)
(Subwoofer)
Mass Approx. 200 g (7 oz.) (Control box)
Approx. 490 g (1 lb. 1 oz.)
(Satellite speaker)
Approx. 8.2 kg (18 lb. 1 oz.)
(Subwoofer)
Cord length 2 m (Control box to subwoofer)
2 m (Power cord)
Power consumptions 31 W
Supplied accessories
Connecting Cable
Optional accessories
Connecting cord RK-G136, RK-G138
Plug adaptor PC-236MS
Design and specifications are subject to change without
notice.
Attach the base with the
anchor holes facing forward
The speaker angle can
be changed by
attaching the base
back to front.
Attach the base with the
anchor holes uppermost
Note
First, be sure to apply a bond (anaerobic
threadlocking material) to the hollow wall
anchor to prevent the screw loosening.
9.5 mm or more
ø 4 mm
5 mm
7 mm
,
Note
Do not hang on the satellite speaker or hang
anything on it.
Connecting cord
(not supplied)
Satellite speaker
(rear)
VOLUME: Controls total volume level.
BASS: Adjusts bass level (Subwoofer)
PHONE: Connect to headphones for personal listening