Sony VGN-FJ270P - Manual

VGN-FJ Series Hard Disk Drive
Replacement Instructions
P/N 994637100 Rev. B 1/2
Step 1. Prepare the Computer.
CAUTION : Make sure the
computer is turned off, the lid is
closed, and the AC Adapter is
disconnected. Failure to do so can
result in damage to the computer.
Place the computer upside down on
a protected surface with the front
edge facing you.
Step 2. Remove the Battery Pack.
Locate the two tabs as shown in the
picture. One is on the left end of the
battery pack, and the other is
located on the right side. Using your
thumbs and fingers push both tabs
in the release direction; gently push
the battery pack away from you.
Step 3. Remove the HDD.
Rotate the computer with the Hard
Disk Drive (HDD) bay facing you as
shown in the picture.
Using the enclosed magnetic
screwdriver, loosen up the two (2)
screws securing the hard disk drive
access door. Remove the access
door and set aside.
Push tabs in the release direction
These easy instructions are intended to guide you through the replacement process.
9 To avoid electric shock please make sure product is turned off and AC Adaptor is disconnected
from the power source. Remove jewelry before you begin work to avoid scratching the surface of
your notebook computer.*
9 Place your notebook computer on a clean, stable and covered surface to avoid damage to the
computer's case.
*
9 Follow the ESD (Electrostatic Discharge) damage prevention instructions:
o
Hold parts by the edges, away from exposed circuitry when possible.
o
Do not walk around excessively as this promotes static build-up.
9 The appearance of the electronic components shown in the illustrations may be different from the
components shipped. This slight difference does not affect the accuracy of these instructions.
* Sony is not responsible for any loss of data associated with your computer or any damage caused by
incorrect handling of the computer under these procedures. The terms of your Sony Limited Warranty
continue to apply.
IMPORTANT!
PLEASE READ BEFORE YOU START