Sony HCD-S500 - Manual (Page 23)

Getting Star
ted
23
IN IN OUT OUT OUT
VIDEO
OUT
R
VIDEO
IN
AUDIO
OUT
AUDIO
IN
L
VIDEO
OUT
R
AUDIO
OUT
L OUTPUT
VIDEO
IN
INPUT
OPTICAL
COAXIAL
V I D E O O U T
A U D I O O U T
V I D E O I N V I D E O I N
V I D E O
A U D I O I N A U D I O I N
AM
L
R
L
R FM
75 Ω
FRONT R FRONT L CENTER
REAR R REAR L WOOFER
SPEAKER
O P T I C A L
D I G I T A L
I N
S V I D E O ( DVD ONLY)
O P T I C A L
( C D O N L Y )
If you connect a digital satellite receiver with the OPTICAL jack
The digital satellite receiver can be connected to the OPTICAL jack instead of the VIDEO IN
and AUDIO IN L/R jacks of the system.
The system can accept both the digital and analog signals. Digital signals have priority over
analog signals. If the digital signal ceases, the analog signal will be processed after 2 seconds.
If you connect a digital satellite receiver without the OPTICAL jack
Connect the digital satellite receiver to the VIDEO IN and AUDIO IN L/R jacks only of the
system.
Setup for the system (for Asian and Australian models)
Setup is necessary for the system, depending on the TV monitor to be connected.
If the colour system of the TV is NTSC or DUAL
Since the colour system of the system is set to NTSC, you can use this system as it is.
If the colour system of the TV is PAL
To set the system to PAL, turn on the system while pressing the X button on the system. To
reset to NTSC, turn off the system and then turn on while pressing the X button on the system
again.
Connecting the AC Power Cord (mains lead)
Before connecting the AC power cord (mains lead) of this system to a wall outlet (mains),
connect the speakers to the system (see page 17).
Connect the AC power cord (mains lead) of your TV/video components to a wall outlet (mains).
VCR Digital satellite receiver TV monitor