beautypg.com

On-screen display remote control – Sony VPL-HW20A User Manual

Page 61

background image

61

Oth

e

rs

On-screen display

Remote control

The picture is too dark.

c Adjust the “Contrast” or “Brightness” of the Picture

menu

properly. (

1 page 44)

The picture is not clear.

c Adjust the focus. (1 page 20)
c Condensation has accumulated on the lens. Leave the projector

for about 2 hours with the power on.

The picture flickers.

c For pictures from a computer, activate “APA” and adjust the

current input signal.

c Adjust “Phase” for “Adjust Signal” in the Screen

menu

properly. (

1 page 49)

The color of characters or
the picture is not
appropriate.

c Select the desired color registration in “Panel Alignment” of

Installation

menu

(

1 page 55).

Symptom

Cause and Remedy

Symptom

Cause and Remedy

On-screen display does not
appear.

c Set “Status” in the Setup

menu to “On.” (

1 page 50)

c Check if the ON/STANDBY indicator should light in green.

The model name does not
disappear from the screen.

c The display mode of the projector may be set at the time of

purchase. Consult with your local dealer or qualified Sony
personnel.

Input terminals do not
appear.

c Set “Auto Input Search” in the Function

menu to “Off”. (

1

page 53)

Symptom

Cause and Remedy

The remote control does
not work.

c Batteries could be weak. Replace them with new batteries.

(

1 page 10)

c Insert the batteries with the correct polarities. (1 page 10)
c If there is a fluorescent lamp near the remote control detector, the

projector may work improperly or inadvertently.

c Confirm the position of the remote control detector on the

projector. (

1 page 7)

This manual is related to the following products: