Actiontec electronic IS560LH - Manual (Page 7)

7
Figure 3b: Windows 95 (or 95A) COM2 Disable Panel
Proceed to the section titled “Installing the Modem.”
For Windows NT 4.0 Installation
Remove all other modem drivers from your operating system. On the Start menu,
click Settings then click Control Panel. In Control Panel, double-click on the Mo-
dems icon. Select the modem you wish to remove and click Remove. Turn off the
computer and physically remove the modem from your system. Do not install your
new modem at this time. Follow the procedures below. Once you remove the old mo-
dem and its drivers from your system, you will need the old modem driver diskette if you
wish to reinstall it at a later date.
On the Start menu, click Programs, then click Administrative Tools, then click
Windows NT Diagnostics. Click the Version tab. “Service Pack 3” (or greater) should
be installed in Windows NT 4.0.