Actiontec electronic IS560LH - Manual (Page 62)

62
%Cn Enable/Disable Data Compression
Enables or disables data compression negotiation on an error corrected link.
d n a m m o C t c e ff E
0 C % n o i s s e r p m o c a t a d s e l b a s i D
1 C % n o i s s e r p m o c a t a d 5 P N M d n a s i b 2 4 . V h t o b s e l b a n E
Result Codes:
K O 1 , 0 = n
R O R R E e s i w r e h t O
AT Commands for Testing and Debugging
The following commands are to be used for testing and debugging only and are not
meant for general use.
&&C Write to/Read from DSP Register
d n a m m o C t c e ff E
- > c o l < C & & T A
> l a v < ,
. > c o l < n o it a c o l t a r e t s i g e r P S D o t > l a v < e u l a v e h t s e ti r w
> c o l < C & & T A . > c o l < n o it a c o l m o rf s d a e r
&&L Line-to-Line Loopback
This command provides a loopback for line-to-line.
&&R Write to/Read from DSP RAM Location
d n a m m o C t c e ff E
-, > c o l < R & & T A
> l a v <
> c o l < n o it a c o l M A R P S D o t > l a v < e u l a v e h t s e ti r w
> c o l < R & & T A > c o l < n o it a c o l m o rf s d a e r