Actiontec electronic Plug n' Play Voice/Fax Modem V.90 ISA - Manual (Page 19)

19
Step 12 Next, find out if the modem has been properly installed and configured for
use with your operating system. On the task bar, click Start. On the Start
menu, click Settings, then click Control Panel, then click Modems. Click
the Diagnostics tab. Click the COM port that the “ISA PnP V.90 Fax Mo-
dem (LKT)” is using, to select it, then click More Info. Windows will com-
municate with the modem for a few seconds, and then report back with the
information shown below. (The COM port being used may vary.)
Configuring Windows NT 4.0
This installation assumes that you have manually set the modem’s jumpers to a COM
2-IRQ 3 setting as outlined in the “Do This First” section at the beginning of the
manual. This is the preferred installation for Windows NT.
Step 1 Reboot the computer and log in to Windows NT 4.0.