Sony CMT-V10IPN User Manual

Personal audio system, Warning, Getting started location of controls

CMT-V10iPN (GB) 4-462-380-11 (1)

Owner’s Record

The model and serial numbers are located on the bottom

exterior of the main unit. Record these numbers in the

space provided below. Refer to them whenever you call

upon your Sony dealer regarding this product.
Model No.

Serial No.

WARNING

To reduce the risk of fire or electric shock,

do not expose this apparatus to rain or

moisture.

To reduce the risk of fire or electric shock, do not expose

this apparatus to dripping or splashing, and do not place

objects filled with liquids, such as vases, on the apparatus.
To reduce the risk of fire, do not cover the ventilation

opening of the apparatus with newspapers, tablecloths,

curtains, etc.

Do not place the naked flame sources such as lighted

candles on the apparatus.
Do not install the appliance in a confined space, such as a

bookcase or built-in cabinet.
As the main plug of AC adaptor is used to disconnect

the AC adaptor from the mains, connect it to an easily

accessible AC outlet. Should you notice an abnormality

in it, disconnect it from the AC outlet immediately.
Do not expose batteries or apparatus with battery-

installed to excessive heat such as sunshine, fire or the

like.
The AC adaptor is not disconnected from the mains as

long as it is connected to the AC outlet, even if the main

unit itself has been turned off.
The nameplate is located on the bottom exterior of the

main unit and on the surface of the AC adaptor.

CAUTION

The use of optical instruments with this product will

increase eye hazard.

Notice for the customers in the Canada

This Class B digital apparatus complies with Canadian

ICES-003.

Notice for the customers in the U.S.A.

The dating code is located on the bottom exterior of the

main unit.

Important Safety Instructions

1) Read these instructions.

2) Keep these instructions.

3) Heed all warnings.

4) Follow all instructions.

5) Do not use this apparatus near water.

6) Clean only with dry cloth.

7) Do not block any ventilation openings. Install in

accordance with the manufacturer’s instructions.

8) Do not install near any heat sources such as radiators,

heat registers, stoves, or other apparatus (including

amplifiers) that produce heat.

9) Do not defeat the safety purpose of the polarized or

grounding-type plug. A polarized plug has two blades

with one wider than the other. A grounding type

plug has two blades and a third grounding prong.

The wide blade or the third prong are provided for

your safety. If the provided plug does not fit into your

outlet, consult an electrician for replacement of the

obsolete outlet.

10) Protect the power cord from being walked on or

pinched particularly at plugs, convenience receptacles,

and the point where they exit from the apparatus.

11) Only use attachments/accessories specified by the

manufacturer.

12) Use only with the cart, stand, tripod,

bracket, or table specified by the

manufacturer, or sold with the apparatus.

When a cart is used, use caution when

moving the cart/apparatus combination to

avoid injury from tip-over.

13) Unplug this apparatus during lightning storms or

when unused for long periods of time.

14) Refer all servicing to qualified service personnel.

Servicing is required when the apparatus has been

damaged in any way, such as power-supply cord or

plug is damaged, liquid has been spilled or objects

have fallen into the apparatus, the apparatus has

been exposed to rain or moisture, does not operate

normally, or has been dropped.

The following FCC statement applies only

to the version of this model manufactured

for sale in the U.S.A. Other versions may

not comply with FCC technical regulations.

NOTE:

This equipment has been tested and found to comply

with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed

to provide reasonable protection against harmful

interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that

interference will not occur in a particular installation.

If this equipment does cause harmful interference to

radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the

following measures:
 Reorient or relocate the receiving antenna.

 Increase the separation between the equipment and

receiver.

 Connect the equipment into an outlet on a circuit

different from that to which the receiver is connected.

 Consult the dealer or an experienced radio/TV

technician for help.

CAUTION

You are cautioned that any changes or modifications

not expressly approved in this manual could void your

authority to operate this equipment.

Note on DualDiscs

A DualDisc is a two sided disc product which mates

DVD recorded material on one side with digital

audio material on the other side. However, since the

audio material side does not conform to the Compact

Disc (CD) standard, playback on this product is not

guaranteed.

Getting Started

Location of Controls

To use the iPod/iPhone

Open the dock by pushing the center of the dock.

Dock

Place the iPod/iPhone.

Operations

Playing a CD/MP3 disc

Select the CD function.
Press CD FUNCTION  on the remote or press

FUNCTION  on the unit repeatedly.

Open the CD door.
Press  (Open/Close)  on the unit.

 (Open/Close) 

Set a disc.
Push the center part of the disc with two fingers until

the disc snaps into its mounted position.

Set a disc with the

label side facing

forward.

Close the CD door.
Press  (Open/Close)  on the unit.

“READING” appears.

Start playback.
Press   on the remote or press   on the

unit.

To eject a disc

Press  (Open/Close)  on the unit and remove the

disc by pulling up the edge of the disc while holding one

finger against the spindle.
Notes

The system will automatically close the CD door  if a few minutes

elapse of no operation with the CD door open.

Do not set a disc with non-standard shapes (e.g., heart, square, star).

The disc may fall into the system and cause irreparable damage.

If you press /  with the CD door open, the system will

automatically close the CD door.

Do not use a disc with tape, seals or paste on it as this may cause a

malfunction.

When you eject a disc, handle the disc by its edge. Do not touch the

surface.

Other operations

Press

Pause playback

  (or   on the unit). To

resume play, press the button again.

Stop playback

 .

Select a folder on

an MP3 disc

+/ .

Select a track or

file

/ // .

Find a point in a

track or file

Hold down /  (or

/  on the unit) during

playback, and release the button at

the desired point.

Select Repeat Play REPEAT  repeatedly until “ ” or

“ 1” appears.

Eject a disc



 on the unit.

To change the play mode

Press PLAY MODE  repeatedly while the player is

stopped. You can select Normal Play mode (“Normal” or

“FLDR” for all MP3 files in the folder on the disc),

Shuffle Play mode (“SHUF” or “FLDR SHUF*” for folder

shuffle), or Program Play mode (“PGM”).

* When playing a CD-DA (audio) disc, FLDR (SHUF) Play performs

the same operation as normal (SHUF) Play.

Notes on Shuffle Play mode

When Shuffle Play mode is set to “SHUF,” the system shuffle-plays

all tracks or files on the disc. When Shuffle Play mode is set to

“FLDR SHUF,” the system shuffle-plays all tracks or files in selected

folder.

When you turn off the system, the selected Shuffle Play mode

(“SHUF” or “FLDR SHUF”) is cleared and the play mode returns to

Normal Play mode (“FLDR”).

Notes on Repeat Play

“

” indicates that all tracks or files will be repeated until you stop

playback.

“

1” indicates that a single track or file will be repeated until you

stop playback.

Notes on playing MP3 discs

Do not save other types of tracks or files, or unnecessary folders on a

disc that has MP3 files.

Folders that have no MP3 files are skipped.

The system can only play MP3 files that have a file extension of

“.mp3.”

Even if a file name has the “.mp3” file extension, if the actual file

differs, playing it may generate loud noise that might even damage

the system.

The maximum number of:

 folders is 255* (including the root folder).

 MP3 files is 512.

 MP3 files in a single folder is 512.

 folder levels (in the tree structure of files) is 9.



 Power (DC IN 9.5 V)

Connect the AC adaptor to the unit.

Plug the AC adaptor into a wall outlet.

 AUDIO IN jack

Connect an external audio component.

 To AC Adaptor
 AM loop antenna
 FM lead antenna (Extend it horizontally.)

Unit (Top)

 Display panel

When the system is powered up, the setting status appears on the display panel.

When the system goes to Standby mode, the setting status disappears from the display panel.

Unit (Front)

Remote sensor

iPod/iPhone connector

CD door

(CD compartment)

Remote indicator

 Remote indicator
Lights in amber when a signal is received from the remote.

Remote

This manual mainly explains operations using the

remote, but the same operations can also be performed

using the buttons on the unit having the same or

similar names.

The SLEEP and TIMER MENU functions indicated in

pink on the remote can be activated using SHIFT .

If you want to operate the SLEEP or TIMER MENU

functions, press and hold SHIFT  and press SLEEP

 or TIMER MENU  button. If you press either

of these buttons without holding SHIFT  pressed,

the system will activate the BASS BOOST or SOUND

EFFECT function.



To use the remote

Remove the battery compartment lid, and insert the two

supplied R6 (size AA) batteries,  side first, matching

the polarities shown below.

Notes on using the remote

With normal use, the batteries should last for about 6 months.

Do not mix an old battery with a new one or mix different types of

batteries.

If you do not use the remote for a long period of time, remove the

batteries to avoid damage from battery leakage and corrosion.



Setting the clock

Press   to turn on the system.

Press and hold SHIFT  and TIMER MENU  to

select the clock set mode.
If “PLAY SET” flashes, press /  repeatedly to

select “CLOCK,” and then press (enter) .

Press 

/  repeatedly to set the hour, then press

(enter) .

Use the same procedure to set the minutes.

Note

The clock settings are reset when you disconnect the power cord or if

a power failure occurs.

To display the clock when the system is off

Press DISPLAY . The clock is displayed for about

8 seconds.

 Antennas

Find a location and an orientation that provide good

reception, and then set up the AM antenna.

Keep the antenna away from the power cord to avoid

picking up noise.

Music discs encoded with copyright

protection technologies

This product is designed to playback discs that conform

to the Compact Disc (CD) standard. Recently, various

music discs encoded with copyright protection

technologies are marketed by some record companies.

Please be aware that among those discs, there are some

that do not conform to the CD standard and may not be

playable by this product.

License and Trademark Notice

iPhone®, iPod®, iPod nano®, and iPod touch® are

trademarks of Apple Inc., registered in the U.S. and

other countries. Lightning

is a trademark of Apple

Inc.

MPEG Layer-3 audio coding technology and patents

licensed from Fraunhofer IIS and Thomson.

Windows Media is either a registered trademark or

trademark of Microsoft Corporation in the United

States and/or other countries.

This product is protected by certain intellectual

property rights of Microsoft Corporation. Use or

distribution of such technology outside of this product

is prohibited without a license from Microsoft or an

authorized Microsoft subsidiary.

All other trademarks and registered trademarks are of

their respective holders. In this manual,

™

and

marks

are not specified.



4-462-380-11 (1)

Personal Audio System

Operating Instructions

CMT-V10iPN