1) setting the ir setup code – Sony DCR-PC5 User Manual
Page 61
61
Editing
Step 2: Setting the VCR to operate with the A/V connecting cable
To edit using the VCR, send the control signal by infrared ray to the remote sensor on
the VCR.
When you connect using the A/V connecting cable, follow the procedures below, (1) ~
(4), to send the control signal correctly.
(1) Setting the IR SETUP code
1
Set the POWER switch to VCR on your camcorder.
2
Turn the power of the connected VCR on, then set the input selector to LINE.
When you connect a video camera recorder, set its POWER switch to VCR/
VTR.
3
Press FN to display PAGE1 (p. 16).
4
Select EDIT SET in
in the menu settings (p. 89).
Then press EXEC.
5
Select CONTROL, then press EXEC.
6
Select IR, then press EXEC.
7
Select IR SETUP, then press EXEC.
8
Select the IR SETUP code of your VCR, then press EXEC. See the following
page about the IR SETUP code.
Dubbing only desired scenes – Digital program editing
4
6~8
5
1
FN
OTHERS
BEEP
COMMANDER
D I SPLAY
V I DEO ED I T
ED I T SET
EXIT
RET.
EXEC
MELODY
OTHERS
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
EXIT
RET.
EXEC
I R
OTHERS
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
EXIT
RET.
EXEC
I R
i. L I NK
OTHERS
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
EXIT
RET.
EXEC
3
OTHERS
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
EXIT
RET.
EXEC
I R
OTHERS
ED I T SET
CONTROL
ADJ TEST
”CUT - I N”
”CUT -OUT”
I R SETUP
PAUSEMODE
I R TEST
EXIT
RET.
EXEC
1