Atlantis Land i I-Fly Wireless Access Point - Manual (Page 12)

3.5 Factory Default Settings
Before configurating this AP, you need to know the following default settings.
Web Configurator
Username : admin
Password: admin
Device IP Network settings in LAN site
IP Address : 192.168.1.1
Subnet Mask : 255.255.255.0
DHCP server : DHCP server disable
Wireless
Channel=6
WEP/WAP=disable
3.5.1 LAN and WAN Port Addresses
The parameters of LAN and WAN ports are pre-set in the factory. The default values are shown
below.
LAN Port
IP address 192.168.1.1
Subnet Mask 255.255.255.0
DHCP server Disable
3.6 Reset
The default username and password are admin and admin respectively.
If you ever forget the password to log in, you may press the RESET button (for 12s) to
restore the factory default settings(sez 3.5).
3.7 Configuration through Web Browser
Open the web browser, enter the local port IP address of this AP, which defaults at
http://192.168.1.1, and click “Go”,